3 Attach Tent to Frame Using Frame Clips

–Attach frame clips along

the edges of tent to frame poles. (illus. 6), (illus. 7)

–Make any adjustments to the tent corner stakes that are needed.

NOTE: Grommets for rainfly pole are on frame clip webbing

illus. 7

illus. 6

Frame clips

Assembled tent without rainfly.

Attach Rainfly

4 –Assemble rainfly pole by

illus. 8 Insert rainfly

poles through the

interlocking shock-corded pole.

pole sleeve on

–Insert rainfly pole through pole

underside of rainfly

sleeve at the center of the front

 

 

curved edge on the underside of

 

 

rainfly. (illus. 8), (illus. 10)

 

 

–Drape rainfly over tent frame, pole

 

Rainfly pole

side down. Rainfly pole should be over

front door.

 

in grommet

–Connect the eight elastic loops with

 

 

hooks, (found at the rainfly corners)

 

 

to the eight fabric loops on the bottom

 

 

row of frame clips. (illus. 9), (illus. 10)

 

 

–Insert the tips of the rainfly poles

 

 

into the grommets on the front

 

 

of tent. (See above illus. 7)

 

 

–Secure rainfly with attachments

 

 

located on underside of fly.

 

 

(illus. 9)

 

 

–Attach and stake out 4 guy lines

 

 

at the front and rear of tent.

 

 

Guy line

illus. 10

Completed tent

 

 

 

 

with rainfly.

Underside of rainfly attaches to frame poles

Hooks attaches

to fabric loop

illus. 9

Rainfly hooks attach to fabric loops on the corner frame clips (illus. 9)

Things You Should Know

Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.

Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use a separate storage bag.

STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.

TENT POLES SHOULD NOT BE LEFT TELESCOPED

TOGETHER DURING STORAGE.

Do not leave your tent set-up for weeks at a time, be aware that expo- sure to the ultraviolet rays of the sun can seriously damage material and/or cause it to become discolored.

WARNING: KEEP ALL FLAME AND HEAT SOURCES

AWAY FROM THIS TENT FABRIC. This tent meets the flammabili- ty requirements of CPAI-84. The fabric may burn if left in continuous contact with any flame source. The application of any foreign sub- stance to the tent fabric may render the flame-resistant properties ineffective.

THE COLEMAN CO., INC.

3600 N. Hydraulic • Wichita, Kansas 67219

1-800-835-3278 • www.coleman.com

PRINTED IN CHINA Rev. 10/06

MADE IN CHINA

Page 2
Image 2
Coleman 9277B151 manual Attach Rainfly, Attach Tent to Frame Using Frame Clips