3 Attach Tent to Frame Using Frame Clips
–Attach frame clips along the edges of tent to frame poles. (illus. 5), (illus. 6)
–Make any adjustments to the tent corner stakes, if needed.
–Stake out remainder of intermediate loops.
illus. 5
Frame Clips
illus. 6
Assembled tent without rainfly. Note the frame clips located on edge of tent.
4 Attach Rainfly
– Assemble rainfly poles, by interlocking
– Insert rainfly pole through the pole sleeves located at the center edges of the underside of rainfly. (illus. 7)
– Drape rainfly over tent frame, pole side down. Rainfly poles go over door and rear window.
– Connect the four elastic loops with “S” hooks, (found at the rainfly corners) to the fabric loops near frame clips.
– Insert tip of rainfly pole into the grommet on the front of the tent and gently arch the pole until you can insert the opposite end in the other grommet. Repeat for back side of tent.
– Secure rainfly with hook & loop and ties located on underside of fly. (illus. 8)
– Attach and stake out guylines.
illus. 7
Rainfly Pole
Sleeves
Underside of rainfly attaches to
frame poles
Guyline
illus. 8 Completed tent with rainfly.
Things You Should Know
•Under certain conditions (cold weather, high humidity, etc.) condensation will form on the inside surfaces of your tent. Condensation is caused by water vapor from your breath, perspiration, or any wet clothing inside your tent. It is NOT LEAKAGE through the tent fabric. It can be minimized by removing wet clothing from your tent and by providing good ventilation through the tent.
•Never store tent, even for a short period of time, without drying it thoroughly and brushing off caked dirt. Do not pack stakes or poles inside your tent. Use separate storage bag.
•STAKES SHOULD BE REMOVED BY PULLING ON THE STAKE ITSELF. NEVER PULL ON THE TENT FABRIC OR TENT STAKE LOOP TO REMOVE STAKE.
•TENT POLES SHOULD NOT BE LEFT TELESCOPED
TOGETHER DURING STORAGE.
•Seam sealer has not been provided with your tent. For additional protection we recommend seam sealing your tent prior to camping. Seam sealer may be purchased through your local retailer or at your local sporting goods store.
PRINTED IN KOREA Rev. 7/04
•Do not leave your tent
WARNING: KEEP ALL FLAME AND HEAT SOURCES
AWAY FROM THIS TENT FABRIC. This tent meets the flammability requirements of
THE COLEMAN CO., INC.
3600 N. Hydraulic • Wichita, Kansas 67219
MADE IN KOREA, ASSEMBLED IN CHINA