14_EventShade-A4.qxd 10/10/06 11:30 PM Page 1

STITCH LINE

14’ EVENT SHADE MODEL 9391-144

Before you begin

Read all instructions before set up.

Select a level site clear of rocks, branches, and other hard or sharp objects to install your shelter.

WARNING: Keep clear of overhead power lines.

It is important to the stability and life of your shelter to have a secure mounting surface.

Consult a local contractor for any local building code requirements.

Enlist the help of at least one other person to assist you when it is time to assemble the shelter.

Parts and Components

To Set Up Shelter

1.Assemble Peak Pole with Center Hub. (Fig. 2)

Fig. 2

2. Assemble both Peak Connector Poles. (Fig.3)

Fig. 3

Description

Part Number

Peak Pole w/Center Hub (1)

9391-1401

Peak Connector Poles (2)

9391-1411

Leg Pole w/Ridge Hub (4)

9391-1421

Pad Feet (4)

9391-1451

Canopy (1)

9391-1461

3.Insert ends of the Peak Connector Poles marked with the arrows into the Peak Pole with Center Hub. (Fig. 4, 5 & 6)

Fig. 4

Center Hub

Fig. 5

Leg Pole w/Ridge Hub (4)

Peak Pole w/Center Hub (1)

Peak Connector Poles

Corner Locator

Pad Feet (4)

Fig. 6

4. Partially assemble the four Leg Poles with Ridge Hub. (Fig. 7) NOTE: Do not assemble the last pole on each side of the Ridge Hubs at

this time.

Important: All four Pad Feet of the Event Shade must be located 14 feet apart. For accurate placement, use the rings on the corner locator to mark locations (Fig. 1):

a)Place white ring on corner locator at point “A” and mark with a stake.

b)Extend rings “B” & “C” out to form a 90° angle amd mark both points with a stake. Distance between point “B” & “C” will measure 19’ 8”.

c)To locate corner “D”, unhook white ring from corner “A” and move diagonally as shown and mark.

d)Remove and stow corner locator for future use.

Fig. 1

Ridge Hub

Fig. 7

5.Insert end of Peak Connector Pole into Ridge Hub (Fig. 8 & 9). Repeat for the remaing three Leg Pole with Ridge Hubs. NOTE: Make sure

metal pin locks into

Metal Pin

Slot

slot on top of Ridge

 

Peak Connector

Hub, you may have to

 

Pole

twist Peak Connector

 

 

from side to side.

 

Fig. 8

Fig. 9

(continued on other side)

Page 1
Image 1
Coleman 9391-144 manual Before you begin, Parts and Components To Set Up Shelter, Corner Locator, Part Number