Coleman 9944-857 manual Setup with Hose* and Refillable Cylinder, Instructions for USE

Setup with Hose* and Refillable Cylinder

*(standard with some models)

WARNING

•Read and follow all instructions and warnings provided with your appliance.

•Do not store LP gas cylinders under or near this appliance.

•Never fill the cylinder beyond 80% full.

•Failure to follow the above instructions exactly may result in fire causing death or serious injury.

•When used with a stove, the maximum pot size is 12 inches diameter and the minimum pot size is 7 1/2 inches diameter.

•When using extension hose always point the cylinder valve toward the fuel inlet of the appliance.

•Maintain proper clearances between cylinder and appliance. The stove must be used on stand or legs with 20- 24 inch clearance between cylinder and inlet of appliance.

•Clean and inspect the hose before each use. If there is evidence of abrasion, wear, cuts or leaks, the hose must be replaced prior to use. The replacement hose must be that specified by The Coleman Company, Inc.

•Never alter in any way or use with any device or part not expressly approved by Coleman.

INSTRUCTIONS FOR USE:

• High Pressure Hose Extension 9941-130 is only for use with Coleman propane appliance models 9941, 9944, and 9948.

•Do not use extension hose when operating appliance on table top. Use disposable 16.4 oz. propane cylinders when operating on table top.

•The LP-gas supply cylinder to be used must be constructed and marked in accordance with the specifications for LP-gas cylinders of the U.S. Department of Transportation (DOT) or the National Standard of Canada, CAN/CSA B339, Cylinders, Spheres and Tubes for the Transportation of Dangerous Goods.

•If a refillable cylinder is used, it must have a collar to protect the cylinder valve.

6

ASSEMBLING HIGH PRESSURE HOSE:

•Make sure burner valves are off. (Fig. 1)

•Attach hose to regulator and regulator to stove. (Fig. 2)

•Attach hose to cylinder. (Fig. 3)

•Open cylinder valve.

•Perform leak check on Hose to Regulator, and Hose to Cylinder connections with soapy water. Bubbles indicate a leak. Check that the connection is not cross-threaded and that it is tight. Perform another leak check. If there is still a leak, remove the cylinder and contact Coleman for service or repairs. (Fig. 4 and 5)

Fig. 1 Fig. 2

Fig. 3 Fig. 4 Fig. 5

DISMANTLING HIGH PRESSURE HOSE:

•Before dismantling high pressure hose, be sure gas pressure in hose is eliminated.

•Ignite stove and turn off gas valve on cylinder.

•Allow flame to self-extinguish.

•When flame is out, close valves on appliance.

•Remove hose.

WARNING

•For use with leg or stand equipped appliances only.

•The gas hose is a tripping hazard. Keep yourself others away from the gas hose when in use or attached to an appliance.

•Do not tip or move the fuel supply.

Protective Collar

20” to 24”

•Turn off fuel at the cylinder and disconnect both ends of the hose when not is use.

•You must follow these instructions exactly or a fire causing death or serious injury may occur.