Grill Assembly — 8400 Series
IMPORTANT: Remove all protective plastic film from stainless steel parts prior to assembly/use. This film is installed at the factory to prevent damage that could occur during shipment and handling.
Tools Required (not provided):
—1/4” Hex Nut Driver
—Phillips Screwdriver
Optional:
— Battery Powered 1/4” Hex Nut Driver
Fig. 6
Fig. 7
Cart Brace Installation
1.Open the left grill door. The two cart braces will be installed at an angle from the cart base to the back side of the compartment. The top end has a tab with a hole in the center. The bottom end has two protruding tabs.
2.Insert the two protruding tabs into the pair of slots located in the cart base (Fig. 6).
3.Lock the cart braces in place by inserting (1) self tapping screw through the back side of the compartment from the outside and through the hole in the tab in each cart brace (Fig. 7).
Right Side Shelf Attachment
1.The right side shelf attaches to the right side of the grill (Fig. 8).
2.Secure the center of the shelf by inserting (2)
3.Secure the front of the shelf by inserting (2) self tapping screws into the front flange underneath the shelf (Fig. 10).
4.Secure the rear of the shelf by inserting (2) self tapping screws into the rear flange underneath the shelf (Fig. 11).
10
Fig. 8
Fig. 9
Fig. 10
Fig. 11
