Attaching the Parent Tray
Holding the Parent Tray with the center compartment facing toward you, align the tongue from both sides of the Parent Tray to the groove on the handle, located opposite the handle adjuster buttons. Slide Parent Tray down until it clicks into 
place and then pull up on it to be sure it 
is secure.
WARNING
TO AVOID BURNS, never place hot liquids in the Parent Tray. To prevent tipping, DO NOT place more than 3 lbs. on the Parent Tray.
Removing the Parent Tray
Locate the tabs underneath the Parent Tray, on each side of the tray. While pull- ing the tab out toward the adjuster but- ton, push the Parent Tray upward.
Using the Rear Brakes
CAUTION
Push the stroller forward to ensure that the brakes are properly engaged.
To lock brakes, push both brake levers DOWN.
To unlock brakes, push both brake levers UP.
Using the Reclining Backrest
1. Press the lever at the top of the seat to the left.
WARNING
Never use seat in reclined position unless the permanently attached safety cover is used.
2.Adjust the backrest gently to any of three positions.
To return the backrest to the upright position, simply lift the backrest gently into place.
CAUTION
Be careful when reclining the backrest while your baby is in the stroller to prevent abrupt changes in seating position.
Using and Adjusting the 5-point Harness
CAUTION
Avoid serious injury from falling or
sliding out. Always use harness.
1.Place the crotch belt between the baby’s legs.
2.Insert both waist belt buckles into the middle plastic piece.
3.Attach each shoulder strap’s hook to the top of the waist belt clips.
4.To adjust the harness or waist belt, loosen the slack on both sides of each buckle.
- 5 -
