Rear Wheel Assembly
Figure A
1.Insert wheel into rear axle (figure A) until it clicks into place. Pull wheel out to ensure it is secure.
2.Repeat this step with the opposite side.
Figure B
Removing the Rear Wheels
Press the release lever as shown in Figure (B) while pulling the rear wheel away from the stroller.
Attaching the Canopy
1.Ensure the canopy is facing the proper direction.
2.Fully insert both sides of the canopy (male) into each side of canopy holders (female).
3.Attach the velcro located on each side of the canopy around the stroller handle.
Removing the Canopy
Pull the velcro apart, squeeze the bottom of the canopy holder (male) and pull the canopy off.
CAUTION
Failure to fully secure the canopy holders can cause the holders to bend. When storing the stroller by laying it down, be sure the canopy is off the ground to prevent it from bending.
Attaching the Kid's Tray
Attaching the Kid's Tray
Push the Kid's Tray into the guardrail posts on the armrest until they lock in place. Check to make sure each side is firmly attached.
Removing the Kid's Tray
Press the buttons on each side of the armrest while pulling the Kid's Tray away.
WARNING
Pull on each side of the Guardrail to make sure that it is completely attached. Do not lift the stroller by the Guardrail.
