

3 Installing the SNMP / Serial Port Card
1.Perform a normal system shutdown on all devices connected to the host UPS in which you are installing the SNMP / Serial Port Card.
2.Place the UPS in Standby mode (from Operate mode or Configure
mode) by pressing the STANDBY button () as shown below.
1
3.Disconnect all devices connected to the UPS receptacles and unplug the UPS.
WARNING: To reduce the risk of personal injury from electric shock, disconnect all loads from the UPS receptacles before unplugging the UPS. Avoid operating the UPS while it is disconnected from the source of electrical power.
4. Remove the Serial Port Card located on the rear of the UPS.
5. Install the SNMP / Serial Port Card. Take care to seat it properly.
Compaq | SNMP / |
| Serial |
| Port |
| Card |
IOIOI

4 Reconnecting All Devices
Reconnect network devices to the UPS and power up the UPS.

5 Connecting to Network
Plug one end of an Ethernet network cable () into the
Power
Communications
Server
Network
Device
1
UPS
2
Ethernet

6 Configuring the SNMP / Serial Port Card
Configure the SNMP / Serial Port Card using the instructions in the Compaq SNMP / Serial Port Card Reference Guide (provided on the Power Products Documentation CD).
Installation is Complete.
n | Before the SNMP / Serial Port Card can be configured, Compaq |
| power management communication software must be installed on |
| every server or workstation protected by the host UPS. To install the |
| software, please refer to the "Configuration" section of the |
| SNMP / Serial Port Card Reference Guide (included on the Power |
| Products Documentation CD). |
n | For information on operating the SNMP / Serial Port Card, please |
| refer to the "Operation" section of the power management |
| communication software guide (included on the Power Products |
| Documentation CD). |
n | Use the Compaq website as an additional information source by |
| logging onto the Internet at www.compaq.com. |
10