
8    Upgrading and Servicing Guide 
6 If you are not replacing the old add-in card with a 
new add-in card, close the open slot by inserting 
the metal slot cover into the opened slot. 
installing an add-in card
1 Align the edge of the add-in card with the slot on 
the chassis and gently but firmly press the card 
straight down into the add-in card slot. The 
whole connector should be seated properly in 
the card slot. 
2 On the back of the PC, replace the bracket cover 
for the add-in card slots, and then install the screw. 
3 Set the chassis upright. 
4 Complete the procedures to replace the side panel, 
and close the PC. See “opening and closing the 
pc“ on page 1. 
NOTE: If the new card or device isn’t working, read 
through the card manufacturer’s installation 
instructions, and recheck all connections, including 
those to the card, power supply, keyboard, and 
monitor. 
replacing the battery
A lithium battery on the motherboard provides backup 
power for the PC’s timekeeping capability. The battery 
has an estimated life expectancy of seven years. 
When the battery starts to weaken, the date and time 
may be incorrect. If the battery fails, replace it with a 
CR2032 lithium battery (3 volt, 220mAH rating) or an 
equivalent battery. 
WARNING: There is danger of explosion 
if the battery is incorrectly replaced. 
Replace only with the same, or 
equivalent, type of battery. Discard used 
batteries according to the manufacturer’s 
instructions. 
1 Complete the procedures to prepare the PC and to 
remove the side panel. See “opening and closing 
the pc“ on page 1. 
2 Gently lay the PC on its side. 
3 Remove any cabling, if necessary, to reach the 
battery. 
4 Remove any memory modules, if necessary, to 
reach the battery. See “adding memory“ on 
page 6. 
5 To remove the battery, push the latch away from the 
battery and lift the battery from the socket. 
6 Install the new CR2032 battery in the socket, with 
the positive (+) side facing the latch.  
7 Replace memory modules or cables you removed. 
8 Set the chassis upright. 
9 Complete the procedures to replace the side panel, 
and to close the PC. See “opening and closing the 
pc“ on page 1. 
Printed in