Compex Systems SGX3226 19

Chapter 3 Hardware Installation

3.Connect the power cord to the power socket on the rear panel of Compex SGX3226.

NOTE

For proper ventilation, do allow about at least 4 inches of clearance on the front and 4 inches on the back of the Switch. This is especially important for enclosed rack installation.

3.1.3Expansion Module Installation

A series of optional expansion modules are available for Compex SGX3226 to enhance the features. As Compex SGX3226 supports the hot plug function, you may install or uninstall the modules without turning off the switch.

1.Please note that Compex SGX3226 is shipped with the Gigabit modules.

2.Insert the module carefully into the expansion module window and push it along the module rail until it stops. Ensure that there is a secure connection to the PCB Board of Compex SGX3226.

3.The Ready LED of the related port will lights up.

4.Tighten the screws on the module.

3.1.4To remove Expansion Module

1.Disconnect any cable from the module.

2.Unscrew and pull out the module slowly from the expansion module slot.

3.Slide the module completely out of the chassis and cover the window with the cover plate, screwing back using the original screws.