Chapter 5 Web-based Interface Configuration for Compex SGX3226

DHCP Start IP Address & DHCP End IP Address

These parameters specify the range of the IP address of which the DHCP Server will assign.

Primary DNS IP Address & Secondary DNS IP Address

DNS is an Internet service that translates domain names into IP addresses. If your WAN connection is using Static IP, you should configure the primary and secondary DNS IP addresses with the DNS information provided by your Broadband Internet Service Provider. For other WAN connection types, the DNS IP addresses is obtained automatically from ISP. The “Always use these DNS servers:” checkbox can be used to disable the automatic process, and your preferred DNS IP addresses can be used.

DHCP Server

DHCP server dynamically assigns IP addresses to the PCs connected in the same network. DHCP comes with a built-in DHCP server that automatically assigns IP addresses, DNS and Gateway information to the computers connected in the same network. It has been pre-configured with IP address and Subnet Mask of 192.168.100.128 and 255.255.255.0 respectively.

1.Enter the values for IP Address, Subnet Mask, DHCP Start and End IP Addresses in its individual fields.

2.You can check on Always use these DNS servers: to disable the function of retrieving DNS IP Address automatically, so that you can enter your preferred DNS IP Address in the Primary and Secondary DNS IP Address field.

3.Next, you can set DHCP Server to Enable if you wish to use the built-in DHCP server of Compex SGX3226.

4.Click on Save button to save your configuration.

NOTE

If your IP Address of the PC has set to “Obtain an IP address automatically”, values in the fields will automatically appeared.

24