aluminio de calefactor Núcleo
cerámica de térmica Capa
terciopelo de Revestimiento
iónicos puertos y cerámica tecnología con calientes Rulos
brillo dar • estática electricidad la eliminar • frizz el reducir para cabello el en presentes positivos iones los neutralizar • PUEDEN: QUE NEGATIVOS IONES GENERA IÓNICA FUNCIÓN LA
.volumen más dar para perfectos son Jumbo Súper rulos Los •
.elegantes y suaves líneas con sofisticados, estilos crear para perfectos son calientes rulos de juego su con vienen que Jumbo rulos Los •
.deseados resultados los obtener para cabello el en rulos los dejar tiempo cuanto enseñará le experiencia La IMPORTANTE:
.horas durará que estilo un lograr para gusto su a cabello el peine luego bucles, los fijar para minuto un durante enfríe cabello el que Permita .libremente rebote cabello el que permita y JALE) LO (NO mente -suave rulo el Deslice .otra la con pinza la remueva y mano una con rulo el Coja rulos: los remover Para .4
.tiempo menos durante cabello el en déjelos suaves, ondas y sueltos bucles lograr Para .más o minutos 10 durante cabello el en rulos los deje firmes, y apretados bucles lograr Para .3
.cabello el en rulo el deja se que tiempo del y rulo del peratura -tem la de depende rizos los de textura La .2
.rulo del abertura la el pinza la introduzca No .pinza una con rulo el Sujete .cabelludo cuero el hacia firmemente éste enrolle y rulo del centro el en cabello del puntas las Coloque .1
CABELLO EL FIJAR CÓMO
| | .mojado cabello el fije No .húmedo mente |
| | -ligera o seco, y limpio estar debería cabello Su .4 |
| | .usarlo de después seguro lugar un en |
| | guárdelo y enfríe aparato el que Permita .usarlo |
| | de después aparato el desconecte Siempre |
| | .encendido esté mientras desatendido aparato |
| | el deje Nunca .tiempo más durante calienten |
| | rulos los que permita apretados, más bucles |
| | crear Para .deseada temperatura la a lleguen |
| | rulos los cuando cabello el fijar a Empiece |
| | .efectivo y rápido más calentamiento un |
| | logrará Esto .calientes estén pinzas las y rulos |
| | los que hasta cerrada cubierta la Mantenga .3 |
| | .translúcido blanco vuelva se térmico indicador |
| | el cuando listos estarán rulos Los .mación) |
| .clavija la de nivel al doble o retuerza jale, lo No | -infor más para CABELLO EL FIJAR CÓMO |
| (véase iónica función la automáticamente |
| .útil vida su prolongar para cuidado con cable el | activarán y rápidamente calentarán rulos los |
| Manipule .niños los de alcance del fuera seguro, | encenderá, se rojo luminoso indicador El .“ON” |
| y seco lugar un en guárdelo y enfríe que permita | posición la en encendido/apagado de ruptor |
| desconéctelo, aparato, el utilizar de Después | -inter el ponga aparato, el conectar Después .2 |
| ALMACENAMIENTO | .seguridad de función esta vencer intente |
| No .electricista un con comuníquese tamente, |
| |
| .reparen | -comple entrara no aún Si .inviértela completo, |
| por entrara no Si .tomacorriente el en manera |
| lo que para autorizado servicio de centro un a |
| sola una de enchufar podrá se seguridad, de |
| regréselo y enfríe que permita aparato, el necte |
| medida Como .otro) que ancho más es polo (un |
| -desco funcionamiento, mal de caso En .suave |
| polarizada clavija una de dotado esta aparato |
| jabón o detergente y húmedo paño un usando |
| este de cable El ..A.C 120V de tomacorriente un |
| rulos los limpie cuando, en vez De .limpio paño | en cable el enchufe y cubierta la Cierre .segura |
| un con calefactores elementos los y aparato el | y llana superficie una sobre aparato el Ponga .1 |
| limpie y enfríe que permita desconéctelo, arlo, | calientes: |
| -limpi necesario sea Cuando .mantenimiento |
| rulos de conjunto el operar Cómo |
| necesita no Casi .trabajo de y tecnología de |
| INSTRUCCIONES |
| nivel óptimo un usando doméstico, uso para |
| diseñado fue calientes rulos de conjunto Su | ESTAS GUARDE |
| MANTENIMIENTO DE INSTRUCCIONES |
.calientes muy vuelven se porque rulos, los calientan que calefactores elementos los toque No .12
.aparato este con extensión una utilice No .11
.oxígeno istrando -admin esté se donde o (spray) aerosol en productos usando estén se donde cionar -fun haga lo ni exteriores, en utilice lo No .10
.aberturas las de ninguna en objeto un inserte ni caer deje Nunca .9
.adormilada o dormida esté mientras aparato este utilice Nunca .8
.similares elementos y cabellos pelusas, de libres aberturas las Mantenga .obstruir puedan se donde sofá, un o cama una como blanda, superficie una sobre aparato el coloque ni aire de aberturas las bloquee Nunca .7
.aparato del alrededor cable el envuelva No .calientes superficies de alejado cable el Mantenga .6
.reparen lo y examinen lo que para autorizado servicio de centro un a Regréselo .dañado estuviese si o caído hubiese se que o mal funcionado hubiese que de después dañados, estuviesen clavija la o cable el si aparato este opere No .5
.fabricante el por recomendados accesorios use Sólo .instrucciones las según mente -sola y diseñado fue cual el para propósito el con únicamente aparato este Use .4
.discapacidad alguna con personas o niños de cerca o sobre por, usado ser debería no aparato Este .3
.aparato del | |
alrededor cable en enrolle ni tuerza jale, No .2 |
.conectado esté mientras | |
desatendido aparato el deje Nunca .1 |
heridas: o incendio electrocución, |
quemaduras, de riesgo el reducir Para | – |
ADVERTENCIA |
.agua el toque No .inmediatamente | |
desconéctelo agua, al cayera aparato el Si .5 |
.líquido otro | |
u agua al caer deje lo ni aparato el coloque No .4 |
.lavabo un o bañera una a empujado ser o caer | |
pueda donde aparato el guarde ni coloque No .3 |
.ducha la o baño el en use lo No .2 |
.usarlo de después | |
inmediatamente aparato el desconecte Siempre .1 |
descarga: por herida o muerte de riesgo |
el reducir Para | |
– PELIGRO |
AGUA DEL | |
ALEJADO MANTÉNGALO |
USARLO DE | |
ANTES INSTRUCCIONES |
LAS TODAS LEA | |
siguientes: las cuales las entre |
seguridad, de básicas precauciones tomar |
debe niños, de presencia la en especialmente |
eléctricos, aparatos use que Siempre |
IMPORTANTES | |
SEGURIDAD DE MEDIDAS |
IMPORTANT SAFETY
INSTRUCTIONS
When using electrical appliances, especially when children are present, basic safety pre- cautions should always be followed, including the following:
READ ALL INSTRUCTIONS
BEFORE USING
KEEP AWAY FROM WATER
DANGER
To reduce the risk of electrocution
1.Always unplug this appliance immediately after using.
2.Do not use while bathing or in the shower.
3.Do not place or store appliance where it can fall or be pulled into a tub or sink.
4.Do not place in or drop into water or other liquid.
5.Do not reach for an appliance that has fallen into water. Unplug immediately.
WARNING
To reduce the risk of burns, electrocution, fire, or injury to persons
1.An appliance should never be left unattended when plugged in.
2.Do not pull, twist or wrap line cord around appliance.
3.Close supervision is necessary when this appliance is used by, on, or near children
or individuals with certain disabilities.
4.Use this appliance only for its intended use as described in the manual. Do not use attachments not recommended by Conair.
5.Never operate this appliance if it has a damaged cord or plug, if it is not working properly, if it has been dropped or damaged, or dropped into water. Return the appliance to a service center for examination and repair.
6.Keep the cord away from heated surfaces.
7.Never block the air openings of the appliance or place it on a soft surface, such as a bed or couch, where the air openings may be blocked. Keep the air openings free of lint, hair, and the like.
8.Never use while sleeping.
9.Never drop or insert any object into any opening or hose.
10.Do not use outdoors or operate where aerosol (spray) products are being used or where oxygen is being administered.
11.Do not use an extension cord with this appliance.
12.Do not touch metal “radiator” strips that hold rollers, as they will be hot.
SAVE THESE
INSTRUCTIONS
OPERATING
INSTRUCTIONS
How to operate your hairsetter
1.Place hairsetter on a firm, flat surface. With the lid closed, plug cord into outlet. This appliance has a polarized plug (one blade is wider than the other). As a safety feature, this plug will fit into a polarized outlet only one way. If the plug does not fit fully into the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. Do not attempt to defeat this safety feature.
2.Once plugged in, turn the unit on by sliding the switch to the on position. The red light will go on, the rollers will heat up quickly and the ionic energy will be automatically activated (please refer to HOW TO CURL YOUR HAIR for further instruction).
3.Allow rollers to heat with lid closed, as this will provide the fastest, most efficient heat- up. Once the rollers are hot, you can begin setting your hair. Allow rollers to heat lon- ger for tighter curls. Never leave your hair- setter on and unattended. Always unplug the hairsetter when not in use. Allow the hairsetter to cool down after use, and store in a safe place.
4.Hair should be clean and dry or slightly damp
– never wet when setting.
USER MAINTENANCE
Your hairsetter is designed for household use and is virtually maintenance-free. This product represents the highest standards of workman- ship and engineering research. If cleaning becomes necessary, disconnect the appliance from the power source. Allow the setter to cool. Clean the unit and the heating posts with a cloth. (Occasionally you may want to clean your rollers. Use a damp cloth and mild detergent or soap.) If any abnormal condition occurs, unplug the hairsetter, allow it to cool, and return it to an authorized service representative for repair.
STORAGE
Allow hairsetter to cool. Handle cord carefully for longer life; avoid jerking or straining at plug con- nections. Place hairsetter out of reach of children in a safe, dry location.
HOW TO CURL YOUR HAIR
1.Place ends of hair on roller and wind toward the scalp. Roll up hair firmly, and secure clip, crossing over roller. Do not place clip in roller slit.
2.The firmness of the curl is regulated by the temperature and the length of time the roller is left in your hair.
3.For tight, firm curls, leave rollers in the hair for at least ten minutes before removing. For soft, wavy curls, the rollers should be removed from the hair after a shorter period of time.
4.Removing roller: hold roller in one hand while removing smart clips with the other. Gently drop roller (DO NOT PULL) and let curl bounce back after roller has been completely removed. Let cool for one minute for a firmly
set curl, and then style your hair into a look that lasts for hours.
IMPORTANT: After using the hairsetter several times, you will find the best timing for the texture of your hair and for the result you desire.
–Jumbo rollers create smooth sleek lines of softer, sophisticated hair styles.
–Use super jumbo rollers for added volume.
THE IONIZING FUNCTION GENERATES NEGATIVE IONS THAT CAN
•neutralize positive charge on flyaway, frizzy hair
•eliminate static electricity
•contribute to shine
The Ceramic Ionic Port System with Ceramic Layered Technology Rollers
Soft
Flocking
Layer
Ceramic
Thermal
Layer
Aluminum
Heating
Core