Continental Electric CE11165 Drying Operation, Replacing batteries, dry batteries R03/LR03X2

COOLING/HEATING/FAN ONLY OPERATION

HANDLING THE REMOTE CONTROLLER

CLOCK	SET TEMP.
		F
FAN SPEED
		4
MODE		FAN
1		3
ENERGY SAVER		TIMER
CLEAN AIR		CANCEL
2		CLOCK
FOLLOW ME RESET LOCK
SLEEP	LED

Start

Ensure unit is plugged and power is available. The OPERATION lamp on the display panel of the indoor unit starts flashing.

1.Mode select button (MODE)

Press to select COOL, HEAT (Not applicable to cooling only models), or FAN ONLY

2.TEMP/TIME button

Set the desired temperature, the most comfortable temperature is between 21 C/70OF to 28 C/82F.

3.Fan speed button (FAN SPEED)

Press to select "AUTO" "LOW", "MED" and "HIGH"

4.ON/OFF button

When the remote controller is off, push this button to start the air conditioner.

	Location of the remote controller.
	.Keep the remote controller where its
	signals can reach the receiver of the
	indoor unit. (a distance of 8m is allowed).
	.When you select the timer operation, the
	remote controller automatically transmits
8m	a signal to the indoor unit at the specified
	time.
	If you keep the remote controller in a

position that hinders proper signal transmission, a time lag of up to 15 minutes may occur.

CAUTIONS

.The air conditioner will not operate if curtains, doors or other materials

DRYING OPERATION

	CLOCK	SET TEMP.
			F
	FAN SPEED
3	MODE		FAN
1
	ENERGY SAVER		TIMER
	CLEAN AIR		CANCEL
2	FOLLOW ME RESET LOCK		CLOCK
	SLEEP	LED

Stop

ON/OFF button

Push this button again to stop the air conditioner. The FAN ONLY mode does not control temperature. Therefore, perform only steps 1,3, and 4 to select this mode.

Start

Ensure unit is plugged and power is available. The OPERATION indicator on the display panel of the indoor unit starts flashing.

1.Mode select button (MODE) Press to select DRY.

2.TEMP/TIME button

Push the "TEMP/TIME" button to set the desired temperature from 21 C/70OF to 28oC/82OF.

3.ON/OFF button

When the remote controller is off, push this button to start the air conditioner.

Stop

ON/OFF button

Push this button again to stop the air conditioner.

Note: The fan speed cannot be adjusted when the unit is in AUTO and DRY mode.

. block the signals from the remote controller to the indoor unit.

Prevent any liquid from falling into the remote controller. Do not expose

.the remote controller to direct sunlight or heat.

If the infrared signal receiver on the indoor unit is exposed to direct sunlight, the air conditioner may not function properly. Use curtains to

.prevent the sunlight from falling on the receiver.

If other electrical appliances react to the remote controller. either move these appliances or consult your local dealer.

	Replacing batteries
	The remote controller uses two
	dry batteries (R03/LR03X2)
	(1) Slide the cover of the battery
	compartment off according to the
	arrow direction, then replace the
	old batteries with new ones.
	(2) Insert the new batteries making
	sure that the(+) and (-) of battery
	are installed correctly.
.	(3) Reattach the cover by sliding it
	back into position.
	After replacing batteries, set the
	remote controller clock.

7 4