Cooper Bussmann BU-905U-L-T quick start Antenna Installation

		Cooper Bussmann BU-905U-L-T Transmitter Quick Start Guide
The LEDs on the front panel indicate the unit status:
LED Status	Indicates
None	No power supply.
OK LED Green	Current status of the unit OK.
OK LED Red	Fault condition detected in unit.
TX LED Flashes	Transmitting Message.
PG LED on	Configuration Cable Connected.
Input LED ON	Input LEDs (i.e., D1,D2, SP, AZ.) light when the corresponding input is active.
	D1		Digital Input 1 is active (Low).
	D2		Digital Input 2 is active.
	SP		Analog Setpoint is active.
	AZ		Analog Input is zero mA
All LEDs medium flash	Medium speed flash (1.6Hz) indicates the module is half-way through the configuration process.
	Medium flash also happens when you set the rotary switch to position 0 when powering on the unit.

Antenna Installation

3A1577Rev1.8 www.cooperbussmann.com/BussmannWirelessResources 5