Cooper Lighting ADC041537 specifications 17W - 120W, A ... Lens, B ... Fasteners, D ... Lamps

DESCRIPTION

Designed to retain the aesthetics of a commercial wraparound, Fail-Safe's FWS Series assures owners an unbreakable, maintenance free, one time installation. Ideally suited for high abuse areas that must maintain a clean, well lighted appearance, Fail-Safe's FWS comes as ceiling or wall mounted, one to four lamp units to provide general ambient illumination.

The FWS Series is specifically designed for use in public access areas where vandalism may occur and for areas that must maintain a clean, well-lighted appearance. Ideal for schools, dormitories, hallways, locker rooms, shower facilities, and restrooms.

SPECIFICATION FEATURES

Catalog #

Project

Comments

Prepared by

FAIL-SAFE®

TypeDate

A ... Lens

Nominal .156, UV stabilized, clear K12, impact resistant, prismatic polycarbonate refractor for high efficiency, low surface brightness and maximum strength.

B ... Fasteners

Captive, stainless steel tamperproof torxhead screws prevent unauthorized access.

C ... Housing Cont.

added strength. Standard white high reflectance polyester powder coat finish. Gloss: 85%; Reflectance: 93%; Hardness Minimum: 2H; Salt Spray: 500 hours.

D ... Lamps

(By Others)

F ... Gasket

Concealed, polyurethane end gaskets inhibit the entrance of environmental contaminants.

G ... Ballast

Copper wound HPF, rapid start, Class P, CBM/ETL ballast is standard.

Labels

C ... Housing		E ... Lens Retention
		Double wall lens channel
Die-formed 16 ga. CRS with
		captivates lens to prevent
welded and ground ends and
		unauthorized fixture penetration.
internal weld bands for
B	C	A	E G

U.L. listed, C.S.A. certified, standard wet label.

DF

FWS

17W - 120W

Fluorescent

12 1/8"

[308mm]

49"

[1245[mm]

SIDE DIMENSIONS	MOUNTING DIMENSIONS
	(4) 3/8" [10mm]	(4) 7/8" [22mm]
	Dia. Mt. Holes	Dia. KO
4 9/16"		2 1/2"	4"
[116mm]		[64mm]	[102mm]
	16"
	[406mm]
	20"
4"	[508mm]
	25"
[102mm]
	[635mm]
	(6) 3/8" [10mm]		(5) 7/8" [22mm]
	Dia. Mt. Holes		Dia. KO
			2 1/2"	4"
			[64mm]	[102mm]
	19 1/2"	19 1/2"
	[495mm]	[495mm]
	22"		22"
	[559mm]		[559mm]
	49"
	[1244mm]
	(4) 3/8" [10mm]		7/8" [22mm]
	Dia. Mt. Holes		Dia. KO
	4 11/16"		3 1/2"
	[119mm]		[89mm]	12 1/8"
			3 1/2"	[308mm]
			[89mm]
12 1/8"
[308mm]	20 1/2"
		20 1/2"
	[521mm]	[521mm]
	49"
	[1244mm]

TORX® is a registered trademark of Camcar Division of Textron Inc.

POLYCARBONATE HIGH ABUSE LUMINAIRE Clear Prismatic or White 1 and 3 Lamp

E N E R G Y D ATA

For Energy Management related technical data to support the performance of this fixture series, refer to the ordering information for input wattage.

Specifications and Dimensions subject to change without notice.	ADC041537
Consult your representative for additional options and finishes.	04/17/2007 1:28:37 PM