Cooper Lighting DE621 manual TRACK LIGHTING Four Circuit, Halo, Cooper Lighting

L 9 0 0 O u t l e t B o x C o v e r

Can be used at any electrical feed connection point (Live, Straight, L, T or X). Size: 5” sq. Screws included.

Finishes: White (P), Black (MB)

L 9 2 3 S t r a i g h t C o n n e c t o r

To connect two track sections end-to-end. May be used as feed point.

Finishes: White (P), Black (MB)

L 9 2 5 T C o n n e c t o r

To connect three track sections into a T Configuration. May be used as feed point.

Finishes: White (P), Black (MB)

L 9 5 4 P e n d a n t K i t

To suspend track from the ceiling. Order as follows: 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3 kits for 8’ Trac; 4 kits for 12’ Trac. 18” threaded steel stem, one canopy and mounting hardware.

Finishes: White (P), Black (MB)

L 9 8 2 C o n d u i t C o n n e c t o r

A Live End Connector for use with surface conduit. Designed to accept standard 3/4” trade size conduit fitting (not supplied).

Finishes: White (P), Black (MB)

L 9 8 3 T- B a r A t t a c h m e n t C l i p

Allows track to be attached to inverted tee ceiling. Order as follows: 2 kits for 2’ Trac; 2 kits for 4’ Trac; 3 kits for 8’ Trac and 4 kits for 12’ Trac.

HALO®

L 9 2 1 L i v e E n d C o n n e c t o r

To start a run.

Finishes: White (P), Black (MB)

L 9 2 4 L C o n n e c t o r

Connects two track sections at a right angle. May be used as feed point.

Finishes: White (P), Black (MB)

L 9 2 6 X C o n n e c t o r

To connect four track sections into a cross configuration. May be used as feed point.

Finishes: White (P), Black (MB)

L 9 6 3	S i n g l e - C i r c u i t t o F o u r - C i r c u i t
	C o n v e r t o r w i t h S w i t c h

Allows any Halo Power-Trac lampholder

(except solid state low voltage and L3218, L3232, L3239, L5120, L5130, L5138) to be used with Four Circuit Trac. One converter is required for each Power-Trac lampholder used. This adapter is designed to fit into the trac in either of two directions. Facing in one direction, it makes contact with circuits 1 and 2, with a 3-position switch (on-off-on) used to select the desired circuit. To connect the fixture with circuits 3 or 4, the adapter is removed from the trac, turned 180°, and is then re-inserted into the trac.

L963 is rated at 500 watts maximum.

Finishes: White (P), Black (MB)

D E 6 2 1 D e a d E n d

Replacement Dead Ends for Four-Circuit track (6 included)

Finishes: White (P), Black (MB)

TRACK LIGHTING Four Circuit

COOPER LIGHTING 317