Cooper Lighting LV211 installation instructions

HALO®

Installation Instructions for LV211 End Feed

701934Customer First Center • 1121 Highway 74 South • Peachtree City, GA 30269 • 770.486.4800 • FAX 770.486.4801

•

Follow installation instructions carefully.

•If unsure about electrical installation

consult a qualified electrician.

• Turn off the power at fuse or circuit breaker box before installation and

maintenance

• Wear rubber-soled shoes and work on a sturdy wooden ladder

•NOTE:Power supplies should be used on a 120-Volt or 277-Volt fused

circuit. (Check labeling)

• This Lighting System must be installed according to National Electric

Code and local building codes.

• Ground power supply to avoid potential electric shock.

• To avoid a hazard to children, account for all parts and destroy all

packing materials.

• WARNING: Risk of ﬁre. Most dwellings built before 1985 have supply

wire rated 60°C. Consult a qualiﬁed electrician before installing.

• If you are unsure about wiring, consult a qualiﬁed electrician.

•Do not install any lampholder closer than 6" from any curtain or

similar combustible material.

•Wireway Channel is intended to be connected only to 12 volt or

24-volt secondary of an isolated type transformer supply.

Do not exceed nominal supply voltage.

•CAUTION:To reduce risk of ﬁre and electrical shock, use only ﬁxtures

and ﬁttings intended for use with Linea LV 100 series channel, or

Linea LV-114 and LV-214 Wire Way channel.

•CAUTION:Do not exceed 25-amp capacity of Wireway channel

(600 watts at 24 volts).

Layout Planning

Carefully plan your layout and determine location and type of feed point

and connectors required. For most installations it is recommended that

the feed point be attached to the channel prior to mounting the channel

to the mounting surface.

NOTE: The maximum recommended length of Wireway channel feed by

a single feed point is 20' when used with electronic power supplies and

40' when used with magnetic power supplies.