IMI CORNELIUS INC g One Cornelius Place g Anoka, MN
Telephone (800) | Facsimile (612) |
|
|
|
|
INSTALLATION INSTRUCTIONS
VOLTAGE PROTECTOR MODULE KIT (P/N 440000401)
ON
230 VAC, 50Hz VANTAGE POST-MIX DISPENSERS
Read and understand these instructions thoroughly before installing this Voltage Protector Module Kit. Purpose of the Voltage Protector Module is to shut the Dispenser down should a too low or a too high power voltage con- dition occur. Retain these instructions as part of your equipment manual.
LOOSE-SHIPPED PARTS
Note: Only qualified personnel should install this Kit.
Unpack and inspect kit. Make sure items are present and in good condition.
Table 1. Loose-Shipped Parts
Item |
|
|
|
No. | Part No. | Name | Qty |
|
|
|
|
1 | XXXXXXXXX | Voltage Protector Module | 1 |
|
|
|
|
2 | 560003334 | Electrical Wire (brown) | 1 |
|
|
|
|
3 | 560003335 | Electrical Wire (black) | 1 |
|
|
|
|
4 | 560003336 | Electrical Wire (blue) | 1 |
|
|
|
|
5 | 325282000 | Screw, Hex Washer Hd; | 4 |
|
|
|
|
KIT INSTALLATION
WARNING: To avoid possible fatal electrical shock or serious injury to Installer, make sure
Dispenser is disconneced from power source before attempting to install this kit.
1.Disconnect electrical power from the Dispenser
2.Remove screw securing the hood, then lift hood straight up off the Dispenser.
3.Remove two screws securing the electrical control box cover, then remove cover for access to the control board.
NOTE: It may be necessary to relocate the transformer to make room for installation of the VOLTAGE PROTECTOR MODULE (item 1) on the refrigeration deck as shown in Figure 1.
4.Remove two screws securing the transformer to the refrigeration deck. Discard the two transformer retain- ing screws.
EIMI Cornelius Inc; 1998
OBSOLETE
July 21, 1998 569000242
