IMI CORNELIUS INC g One Cornelius Place g Anoka, MN
Telephone (800) | Facsimile (612) |
|
|
|
|
INSTALLING REPLACEMENT AGITATOR MOTOR
KITS (P/N 569000207 AND P/N 569000208)
ON
VANTAGE DISPENSERS
IMPORTANT: Only qualified Personnel should install this kit.
Unpack and inspect the kit. Make sure all kit items are present and in good condition.
Table 1. Loose-Shipped Parts
Item |
|
|
|
No. | Part No. | Name | Qty. |
|
|
|
|
1 | 314072000 | Agitator Motor Ass’y, 115 VAC (Kit P/N 569000207) | 1 |
| 314150000 | Agitator Motor Ass’y, 230 VAC (Kit P/N 569000208) | 1 |
|
|
|
|
2 | 319828000 | Screw, Thread Rolling, Phil Pn Hd; No. | 3 |
|
|
|
|
3 | 560001745 | Mounting Template | 1 |
|
|
|
|
4 | 000268010 | Drill Bit, 5/32 | 1 |
|
|
|
|
REMOVING OLD AGITATOR MOTOR ASSEMBLY
WARNING: Disconnect electrical power from the Unit to prevent personal injury before attempting any internal maintenance. Only qualified personnel should service the internal components or electrical wiring.
1.Disconnect electrical power from the Dispenser.
2.Remove hood from Dispenser, then remove cover from electrical control box (see Figure 1).
3.Disconnect old agitator motor assembly electrical wires from L1 and L2 terminals on the PC board (see Figures 1 and 4) inside the electrical control box.
4.Remove old agitator motor assembly from refrigeration deck. Discard old motor and it’s mounting screws.
INSTALLING NEW AGITATOR MOTOR ASSEMBLY
1.Cut out “AGIT PORT
2.Temporarily install the electrical control box cover to protect the PC boards from metal shavings while drilling. Center punch two hole locations indicated on the mounting template, then using DRILL BIT (item 4) drill indicated holes in the refrigeration deck.
EIMI Cornelius Inc; 1997
May 20, 1997 560001744