ED/DF300 22” CCM322/522 Nordic Style Lid Kit Installation Instructions
INSTALLATION INSTRUCTIONS
ED/DF300 22” CCM322/522 NORDIC BLACK/GRAY STYLE LID KITS
This Nordic style kit applies to the Cornelius 22” wide CCM322/522 ice maker.
Item | Part No. | Name | Qty. | |
No. | ||||
|
|
| ||
|
|
|
| |
1 | 15210 | Lid Assembly | 1 | |
|
|
|
| |
2 | 22127 | Icemaker Mounting Bracket | 2 | |
|
|
|
| |
3 | 50904 | RTV. 3Oz Tube | 1 | |
|
|
|
| |
4 | 52946 | Manual Ice Fill Cover, Black | 1 | |
| 52964 | Manual Ice Fill Cover, Gray |
| |
|
|
|
| |
5 | 91957 | Label, “Disconnect Power Before | 1 | |
|
| Cleaning” |
| |
|
|
|
| |
6 | 620042919 | ED300 Ice Baffle | 1 | |
|
|
|
| |
7 | 620701601 | #10 x 1/2” LG. Sheetmetal Screw | 8 | |
|
|
|
| |
8 | 620701902 | 4 | ||
|
|
|
| |
9 | 620701901 | Sealing Washer | 4 | |
|
|
|
| |
10 | 621701903 | #8 Nylon Washer | 4 | |
|
|
|
| |
11 | 620204725INS | Installation Instructions | 1 | |
|
|
|
| |
13 | 630500109 | Bin Stat | 1 | |
|
|
|
|
CAUTION: Disconnect electrical power to the dispenser before proceeding with the icemaker adapter kit installation.
WARNING: The dispenser must be secured with
NOTE: Adjust the automatic agitation timer located in the dispenser’s electrical control box to 5 seconds
on, 20 minutes off. Access to the timer is provided by removing the merchandiser/upper front panel.
1.Remove the (2) screws from each side of the dispenser cabinet. and the plastic hopper covers (2) that were shipped with the unit.
2.Place the “K” style lid on the unit and use the (4) screws that were removed to fasten the lid in place.
3.Install the ice baffle on the lid assembly as shown in Figure 2.
IMPORTANT: The baffle prevents ice from
4.Seal the icemaker to the top of the dispenser after determining the correct location for the ice maker (see Figure 1).
A.Run beads of RTV around the opening in the lid and inside of the perimeter of the ice maker outline so that the ice maker will set on the RTV.
B.Set the ice maker onto the lid and position it as required.
C.Wipe away the excess RTV.
5.5. Drill .147 diameter holes into the ice maker cabinet and the dispenser lid using the icemaker mounting brackets as templates. USE CAUTION SO AS NOT TO DRILL INTO ANY ICEMAKER COMPONENTS (CONDENSER, TUBING, ETC.). Secure the brackets using the #10 sheetmetal screws provided.
6.Install the wire form bracket, supplied with the bin stat kit (item 4), through the 5/8” diameter hole in the bottom of the ice maker. Wrap the eye of the wireform over the stud near the hole to the end of
Release Date: October 5, 2007 | www.cornelius.com | Revision: A |
© 2007, IMI Cornelius Inc. | - 1 - | Publication Number: 620204725INS |