Cornelius WCC700 manual Dispenser Kit Number, Df/Ed

Models: WCC700

1 5
Download 5 pages 6.23 Kb
Page 1
Image 1
Dispenser

IMI CORNELIUS INC.

One Cornelius Place

Anoka. MN 55303-6234

Telephone (800) 238–3600

Facsimile (763) 422–3246

DUAL DF/ED 2XX LID KIT FOR THE FOLLOWING ICE MAKERS: Cornelius Extreme 522 and Wilshire WCC 700

Dispenser

Kit Number

DF/ED 2XX

629087947

Components

 

Qty

1.

Cover

620043547

2

2.

Lid Assembly (XAC 522 Icemaker)

620046064

1

3.

Lid Assembly (WCC 700 Icemaker)

620046060

1

4.

Mounting Bracket

22127

4

5.

Screw, #8 SM

70217

20

6. RTV

50904

1

7.

Label

91957

2

8.

Instructions

620919550

1

9.

Nut, Nylon

620701902

4

10.

Washer, Nylon

620701903

4

11. Washer, Sealing

620701901

4

12.

Ice Baffle

620037003

2

13.

Gasket Strip

620505802

2

14.

Binstat Kit

631500109

1

15.

Plate, Top Cover

620044644

1

1.Unpack kit. Refer to Figures 1 & 2 for component detail.

2.Attach the ice baffles (item 12) to the lid assemblies (items 2 & 3) using the gasket strips, washers and acorn nuts provided (figure 1).

3.Replace the center–mounting bracket supplied with the dual merchandiser kit with the top cover plate sup- plied with this kit (item 15). Failure to do this will prevent the adapter kit from functioning properly.

4.Set the lid assembly onto the dispenser. Using the slotted holes on the side of the lid as a template, drill four

(4) 9/64” diameter holes at the bottom of the slots (Figure 2).

Note: Use extreme care not to drill into the hopper. Use a drill stop to ensure that the drill bit does not penetrate deeper than ¼” past the sheet metal. Failure to do so could result in a hole in the hopper, great- ly reducing the efficiency of both the dispenser and ice maker.

5.Fasten the lid to the dispenser with four (4) #8 sheet metal screws (item 5), two on each side.

6.Seal the ice maker to the top of the dispenser as follows:

A.Run beads of RTV (item 7) around the opening in the lid assembly and the inside of the perimeter of the ice maker outline so that the ice maker will set on the RTV. Make sure that some RTV is applied inside the nutserts on the lid assembly.

B.Set the ice maker onto the lid and position it as required.

C.Insert the thumbscrews (item 5) into the lid to attach the icemaker to the lid (Figure 3).

D.Wipe away the excess RTV.

IMI Cornelius Inc; 2001

November 30, 2001

Revision A

E

 

 

 

620919550

Page 1
Image 1
Cornelius WCC700 manual Dispenser Kit Number, Df/Ed