Direction for use
Fill with water before plugging the power cord. (No water may cause nebulizer malfunction.)
Coins, nails and screws in the reservoir result in the malfunction of the nebulizer part. Please check before starting. In addition, disconnect the water tank, drain the water in the reservoir thoroughly and check if the
After initially filling with the water, the humidification starts after approx. 1minutes. Wash the water tank before initial use to spray more comfortable mist.
Filling the water tank
Detach the mist outlet and lift out the water tank.
Lift out the water tank by using the handle on the lower water tank.
If the water tank is carryed with the mist outlet attached, the appliance may be damaged by twisting of the mist outlet.
Turn the soft water tank cap anti- clockwise to open the cap.
Fill water in the water tank.
Use clean tap water.
Do not use cold water below 42.8 (6 | and warm |
water above 95 35 |
|
Doing so may cause nebulizer malfunction. | |
The use of underground water or water with a lot of rust or dregs may cause weak mist output or appliance failure.
After topping up with water, dry the water tank with a clean cloth.
Turn the soft cap clockwise until the cap is closed thoroughly.
Close the cap after aligning the ‘Close’ mark to the cap mark and the bottom mark
of the tank.
Fit the mist outlet in the water tank so it faces the front of the appliance for spraying.
