I I I I
MOUNTING LASER SYSTEM
1.Locate laser package and find the following parts as shown in (Fig. 14):
a)Laser light system.
b)Two 6/32 screws with washers.
2.Loosen bolt and remove cover. Install two AAA batteries (Fig.15), making sure both terminals are
positioned correctly as the marks on the cover show, then replace cover.
3.Screw laser system onto blade guard (Fig. 16).
4.Mark a cut line on a piece of scrap tile. Turn on the laser and align the laser with the cut mark by loosening the bottom screw on the laser system (Fig. 17).
5.Cut the tile, paying attention to the position of the blade relative to the laser beam.
6.Laser beam can be adjusted to the cut line.
7.Repeat Steps 4 through 6 until laser is properly adjusted, then tighten bottom screw.
ibeingOTE: used,To avoid corrosion, remove the batteries when laser system is not Ji
INSTALLING THE BLADE
i _WARNING:Disconnect the power supply before installing or making i adjustments to the blade.
1.FIRST, to disconnect the water supply, press the blue ring and pull out the water supply tube from the inlet connection on the blade guard (Fig. 18).
2.NEXT, remove the blade guard by removing the two securing screws, (Fig. 19).
3.REMOVE blade securing nut and outer flange from shaft. Place blade onto shaft. Directional arrows on blade MUST line up with
directional arrow on blade guard, so that material to be cut is against the direction of rotation.
4.TIGHTEN by using the hexagonal wrench to turn the
16
INSTALLING THE BLADE cont.
5.REPLACE blade guard with the two securing screws.
6.
RIP/MITER GUIDE INSTALLATION
1.To install the rip/miter guide, slide aluminum arm of rip/miter guide into the groove in the fence on saw table (Fig 21).
2.The rip miter/guide can be made stationary by tightening the screw and butterfly knob located on the arm of the rip/miter guide.
WATER PUMP SETUP AND CONNECTION
]
[ ZmustWARNING:Tobe unplugged preventwhen connectingthe possibilitywaterofpumpelectrical. shock, the tile saw J
. Check to be certain that the water supply tube is connected to the inlet connection on the blade guard
(Fig. 18).
. To connect the water pump power cord, locate the black cover box under the table. Loosen butterfly knob and remove black cover box (Fig. 21 a). Plug in water pump cord, making sure fit is secure. (Fig. 22) Replace black cover box and
. Connect tube under table to water pump discharge fitting (Fig. 23).
4.Fit water pump into housing in water tray, making certain pump discharge fitting aligns with cutout in tray housing (Fig. 24)
]
i zqualifiedCAUTION"replacementTo preventparts.the possibility of electric shock, use only Sears l
17
I
I2-2-06
I
I
