DESCRIPTION cont.
KNOW YOUR BUFFER / POLISHER cont.
Perimeter | On/Off | Fig. 2 | |
Handle System |
|
| |
|
| Slide Switch |
|
Stub Lengh
Cord
Hook and
Loop Strip
Foam Pad Base
PRODUCT SPECIFICATIONS
Pad Diameter | |
|
|
Motor OPM | 3800 |
|
|
Rating | 120 volts, 60 Hz AC |
|
|
Amps | 1.0 |
|
|
OPERATION
Before attempting to use your tool, familiarize yourself with all of the operating features and safety requirements.
!WARNING: IF ANY PARTS ARE MISSING, DO NOT OPERATE THIS BUFFER / POLISHER UNTIL THE MISSING PARTS ARE REPLACED. FAILURE TO DO SO COULD RESULT IN POSSIBLE SERIOUS PERSONAL INJURY.
!CAUTION: ALWAYS wear eye protection while operating this power tool.
12
OPERATION cont.
BEFORE YOU BEGIN TO WAX, BUFF AND POLISH YOUR CAR:
1.Remove all road tar, excess grease spots and bug stains with a
2.Wash, clean and dry your vehicle.
3.Make sure the work area is dry.
ATTACHING THE WAX APPLICATOR BONNET TO THE FOAM PAD (See Figure 3)
! WARNING: When changing | Fig. 3 |
accessories, BE SURE that the switch is |
|
in the OFF position and the cord is |
|
unplugged. |
|
1. Place wax applicator bonnet on foam pad as shown in Fig. 3.
2.ALWAYS make sure that the elastic strip on the bottom of the bonnet is securely tucked on the underside of the foam pad.
APPLYING WAX TO BONNET (See Figures 4 and 5)
IMPORTANT: DO NOT APPLY WAX DIRECTLY |
| |
Fig. 4 | ||
ON CAR! | ||
| ||
Applying Paste Wax to Bonnet (See Figure 4) |
|
1. Spread a heaping teaspoon of wax evenly over entire surface of applicator bonnet using a putty knife or any other flat object (See Fig. 4).
Applying Liquid Wax to Bonnet (See Figure 5) | Fig. 5 | |
1. Apply three swirls of wax over applicator | ||
| ||
bonnet (See Fig. 5). |
| |
2. This should be enough to cover 1/4 of car |
| |
surface. |
| |
3. For the second and third and fourth applications, |
| |
only use about one half as much as on first |
| |
application. The bonnet will not absorb as |
| |
much wax on these applications. |
|
13
