Craftsman 315.1191 manual Battery Protection Features, C3 Energy Indicator Window

A WARNING: Do not allow familiarity with tools to

make you careless. Remember that a careless fraction of a second is sufficient to inflict serious

injury.

A WARNING: Always wear safety goggles or safety glasses with side shields when operating tools. Failure to do so could result in objects being thrown

TO REMOVE BATTERY PACK

See Figure 2.

[] Lock the switch trigger by placing the direction of rotation selector in the center position.

[] Locate latches on end of battery pack and depress to release battery pack from the tool.

[] Remove battery pack.

into your eyes, resulting in possible serious injury.

A WARNING: Do not use any attachments or

A

WARNING: Battery products are always in operat- ing condition. Therefore, the switch should always be locked when not in use or carrying at your side.

accessories not recommended by the manufacturer of this tool. The use of attachments or accessories

not recommended can result in serious personal injury.

APPLICATIONS

You may use this product for the purposes listed below:

[] Drilling in all types of wood products (lumber, plywood, paneling, composition board, and hard board)

[] Drilling in ceramics, plastics, fiberglass, and laminates

[] Drilling in metals

This product will accept DieHard® 19.2 V lithium-ion bat- tery packs and Craftsman 19.2 V nickel-cadmium battery packs.

For complete charging instructions, refer to the Operator's Manual for the battery packs and chargers listed in the General Safety Rules.

BATTERY PROTECTION FEATURES

DieHard® 19.2 V lithium-ion battery packs are designed with features that protect the lithium-ion cells and maximize battery life.

If the tool stops during use, release the trigger to reset and resume operation. If the tool still does not work, the battery needs to be recharged.

TO INSTALL BATTERY PACK

See Figure 2.

[] Lock the switch trigger by placing the direction of rotation selector in the center position.

[] Place battery pack in the tool. Align raised rib on battery pack with groove inside tool.

[] Make sure the latches on each side of the battery pack snap into place and battery pack is secured in tool before beginning operation.

CAUTION: When placing battery pack in the tool, be sure raised rib on battery pack aligns with groove inside tool and latches snap into place properly. Improper assembly of battery pack can cause damage to internal components.

C3 ENERGY INDICATOR WINDOW

See Figure 2.

The C3 energy indicator window located on the side of the handle, just above the base, will light when a DieHard® 19.2 V lithium-ion battery pack is installed and has charge.

NOTE: Feature will not light with Craftsman 19.2 V nickel- cadmium battery packs.

C3 ENERGY

WINDOW

_, k_ INDICATOR

_'_BATTERYPACK

LATCHES

DEPRESSLATCHESTO

RELEASEBATTERYPACK

Fig. 2