Craftsman 320. 61352 warranty Battery Protection, To Attach Battery Pack Fig

LOW BATTERY CAPACITY iNDiCATOR

•If the LED begins to rapidly flash when the trigger switch is depressed, the battery pack's power has run out, and the battery pack should be recharged.

Unlike other battery pack types, Lithium-Ion battery packs deliver fade-free power for their entire run time. The tool will not experience a slow, gradual loss of power as you work. To signal that the battery pack is at the end of its run time and needs to be charged, power to the tool will drop quickly.

NOTE: The LED may also flash due to an overload or high temperature situation (see BATTERY PROTECTION).

BATTERY PROTECTION

The circuitry protects the battery pack from extreme temperature, over-discharge, and over-charge. To protect the battery from damage and prolong its life, the battery pack circuitry will turn off the battery pack if it becomes overloaded or

if the temperature becomes too high during use. This may happen in extremely high torque, binding, and stalling situations. This intelligent system will shut down your battery pack if its operating temperature exceeds 176°F (80°C) and will begin normal operation when it returns to 32°F (0°C) - 122°F (50°C).

The LED light will begin to flash slowly if the battery circuitry detects a momentary overload.

NOTE: The battery can automatically reset. If the LED continues to flash, that indicates that the capacity is too low. Place the battery on the charger for charging (see BATTERY CAPACITY INDICATOR, above).

NOTE: A significantly reduced run time after fully charging the battery pack indicates that the battery is near the end of its usable life and must be replaced.

TO ATTACH BATTERY PACK (Fig. 3)

_1_ CAUTION: Avoid the

Fig. 3

possibility of accidental starting: always take care not to activate the trigger switch when you are attaching the battery pack or making any adjustment to the tool.

1.Align the raised portion on the battery pack with the grooves on the bottom of the hammer, then attach the battery pack to the hammer as shown.

61352 Manual_Revised_08 0924 Page 13