Craftsman 351.215 Installation, Onboard Storage, Power Source, Grounding Instructions

Knob

2″ Drum

Washer

Direction Arrow on Insert

Figure 4 - Attaching 2″ Drum with Sleeve

ONBOARD STORAGE

Onboard storage is provided for all drums, inserts and washers.

Table

Inserts

Drum Washers

Drums with

Sleeves

Figure 5 – Onboard Storage

INSTALLATION

Refer to Figures 6, 7 and 8, pages 4 and 5.

POWER SOURCE

WARNING: Do not connect sander to the power source until all assembly steps have been completed.

The motor is designed for operation on the voltage and fre- quency specified. Normal loads will be handled safely on volt- ages not more than 10% above or below specified voltage. Running the unit on voltages which are not within range may cause overheating and motor burn-out. Heavy loads require that voltage at motor terminals be no less than the voltage specified on nameplate.

•Power supply to the motor is controlled by a single pole locking rocker switch. Remove the key to prevent unautho- rized use.

GROUNDING INSTRUCTIONS

WARNING: Improper connection of equipment grounding conductor can result in the risk of electrical shock. Equipment should be grounded while in use to protect operator from electrical shock.

•Check with a qualified electrician if grounding instructions are not understood or if in doubt as to whether the tool is properly grounded.

•This tool is equipped with an approved 3-conductor cord rated at 150V and a 3-prong grounding type plug (Figure 6) for your protection against shock hazards.

•Grounding plug should be plugged directly into a properly installed and grounded 3-prong grounding-type receptacle, as shown (Figure 6).

Properly Grounded Outlet

Grounding Prong

3-Prong Plug

Figure 6 - 3-Prong Receptacle

•Do not remove or alter grounding prong in any manner. In the event of a malfunction or breakdown, grounding pro- vides a path of least resistance for electrical shock.

WARNING: Do not permit fingers to touch the terminals of plug when installing or removing from outlet.

•Plug must be plugged into matching outlet that is properly installed and grounded in accordance with all local codes and ordinances. Do not modify plug provided. If it will not fit in outlet, have proper outlet installed by a qualified electrician.

•Inspect tool cords periodically, and if damaged, have repaired by an authorized service facility.

•Green (or green and yellow) conductor in cord is the grounding wire. If repair or replacement of the electric cord or plug is necessary, do not connect the green (or green and yellow) wire to a live terminal.

•Where a 2-prong wall receptacle is encountered, it must be replaced with a properly grounded 3-prong receptacle installed in accordance with National Electric Code and local codes and ordinances.

WARNING: This work should be performed by a qualified electrician.

A temporary 3-prong to 2-prong grounding adapter (see Figure 7) is available for connecting plugs to a two pole outlet if it is properly grounded.

Grounding Lug	Make Sure This
	Is Connected
Adapter
	To A Known
3-Prong Plug
	Ground
	2-Prong
	Receptacle

Figure 7 - 2-Prong Receptacle with Adapter

•Do not use a 3-prong to 2-prong grounding adapter unless permitted by local and national codes and ordinances.

(A 3-prong to 2-prong grounding adapter is not permitted in Canada.) Where permitted, the rigid green tab or terminal on the side of the adapter must be securely connected to a permanent electrical ground such as a properly grounded water pipe, a properly grounded outlet box or a properly grounded wire system.

•Many cover plate screws, water pipes and outlet boxes are not properly grounded. To ensure proper ground, grounding means must be tested by a qualified electrician.

4