CARTON CONTENTS
Check carton contents against the fol-
lowinglist,
Model 358.792430
•Brushcutter Attachment
•Handlebar (with Clamp and Knob)
•Handlebar Clamp Base (with Spacer Tabs)
•Shoulder Strap
•Upper Shoulder Strap Clamp
•Lower Shoulder Strap Clamp (with Spacer Tabs)
•Handlebar Clamp Screws (4)
•Shoulder Strap Clamp Screws (2)
•Attachment Hanger
•Hex Wrench
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find that parts are missing or damaged, call
ASSEMBLY
z't
tl WARNING: If received assembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
•A hex wrench (provided) is required for assembly.
INSTALLING BRUSHCUTTER AT- TACHMENT
CAUTION: When removing or instal- ling attachments, place the unit on a
flat surface for stability,
1.Loosen the coupler by turning the knob counterclockwise.
Coupler
LOOSEN
TIGHTEN Knob
Coupler Primary Hole
\ /_uide Recess
Upper Locking/ Lower
Tube Release Attachment
Button
_11_WARNING: Make sure the lock-
ing/release button is locked in the pri- mary hole and the knob is securely tightened before operating the unit.
HANDLEBAR ASSEMBLY
DANGER: RISK OF CUT. To
avoid serious injury, the barrier portion of the handlebar must be installed as shown on the upper tube of the power-
head to provide a barrier between op- erator and the spinning blade. Attach tube clamp above arrow on safety warn- ing decal on the upper tube (powerhead end of unit). Ensure handlebar is posi- tioned on handlebar clamp between the arrows on the handlebar decal.
NOTE: The tube clamp base has four spacer tabs attached, These tabs are provided to adapt this attachment for use with powerheads that have a 1" di- ameter upper tube (the tube clamp will not tighten down securely on the 1" di- ameter upper tube without using these spacer tabs). The tabs must be broken
off completely before use and placed over the screw holes on the clamp base.
These tabs are not needed for power- heads with a 7/8" upper tube.
HANDLEBAR CLAMP BASE
Spacer T_ | _lb_ |
2.Remove the tube cap from the brushcutter attachment (if present).
3.Position locking/release button of attachment into guide recess of coupler.
4.Push the attachment into the cou- pler until the locking/release button snaps into the primary hole,
5.Before using the unit, tighten the knob securely by turning clock- wise.
Spacer Tabs _ |
|
|
posi!ioned for use | _ | _ |
on 1 diameter | __p.,,'__ | |
upper tube | _U |
|
1.Place the tube clamp over the up- per tube above the arrow on the safety decal.
2.Position the clamp base under the upper tube and align the tube
5