theseparts. Failure to do so is a viola- tion of law. Contact a Sears Service
Center fur the correct parts.
SPECIAL NOTICE: Exposure to vibrations through prolonged use of gasoline powered hand tools could cause blood vessel or nerve damage
in the fingers, hands, and joints of people prone to circulation disorders or abnormal swellings. Prolonged use in cold weather has been linked to blood
vessel damage in otherwise healthy
CARTON CONTENTS
Check carton contents against the fol- lowing list,
Model 358=796100
•Trimmer
•Shield
•Wing Nut (screwed onto shield)
•Container of line
•Container of oil
Examine parts for damage. Do not use damaged parts.
NOTE: If you need assistance or find parts missing or damaged, call
It is normal fur the fuel filter to rattle in the empty fuel tank.
Finding fuel or oil residue on muffler is normal due to carburetor adjustments and testing done by the manufacturer.
ASSEMBLY
WARNING: If received as-
sembled, repeat all steps to ensure your unit is properly assembled and all fasteners are secure.
ADJUSTING THE HANDLE
WARNING: When adjusting the handle, be sure it remainsbetween the triggerand the safety label,
people. If symptoms occur such as numbness, pain, loss of strength, change in skin color or texture, or loss of feeling in the fingers, hands, or joints, discontinue the use of this tool and seek medical attention. An anit-
vibration system does not guarantee the avoidance of these problems. Us- ers who operate power tools on a con- itnual and regular basis must monitor
closely their physical condition and the condition of this tool.
•Loosen wing nut or knob on handle.
•Rotate the handle on the tube to an upright position; retighten wing nut.
WARNING: The shield must be proparly installed. The shield provides partial protection from the risk of thrown objects to the operator and others and is equipped with a line limiter whkth cuts excess line to the proper lengl_. The line limiter (on underside of shield) is sharp and can cut you. For proper oitentaiton, see illusbaiton in OPERATION sec_on.
•Remove wing nut from shield.
•insert bracket into slot as shown.
•Pivot shield until bolt passes through hole in bracket.
•Securely tighten wing nut onto bolt.
0o,
Shield
