REMOVE THE INLET RESTRICTOR
An inlet restrictor is used when using your unit as a blower. This restrictor is not used during vacuum use and must
be removed during assembly for vacu- um use.
NOTE: Be sure to keep the inlet re- strictor for using your unit as a blower.
1.Ensure unit is stopped and extension cord is unplugged.
2.Open the inlet cover by inserting the tip of a screwdriver into the latch area on the vacuum inlet cover.
Gently tilt handle of screwdriver to- ward the front of the unit while pull- ing up on the vacuum inlet cover with your other hand.
Latch Area
Impeller
3.While holding the inlet cover open, align the arrows and insert the vac- uum tube into the opening. Twist the tube clockwise until it is seated. A second arrow on the vacuum tube
will align with the arrow on the unit once the tube is twisted completely into place.
Align arrows on tube & unit
4.To attach the lower vacuum tube to the upper vacuum tube, first align the arrows on the two tubes. Then, press the two tubes together until the lower tube is securely seated in the upper tube (about 3 inches).
UpperTube
Vacuum Inlet Cover
LowerTube
ATTACH THE COLLECTION BAG
3.Turn the inlet restrictor counterclock- wise and remove it from the unit. Do not close the inlet door. You will next attach the vacuum tubes.
Slide the opening of the collection bag over the blower outlet, Pull the velcro
strap tightly through the buckle and se- cure to the velcro tabs.
/ VacuumNOTE: Make sure the velcro strap is located on the blower outlet as shown
below, Also, make sure the zipper on the bag is completely closed.
Inlet Cover
_leettri_r/Tq
ATTACHING THE VACUUM TUBES There are 2 vacuum tubes, an upper and lower tube, The upper tube is cut straight on both ends and attaches to the blower unit, The lower tube at- taches to the upper tube, and has an angled end that you point toward the ground during vacuum use,
1.Ensure unit is stopped and exten- sion cord is unplugged.
2.Locate the arrows on the upper vac- uum tube and on the vacuum inlet area of the unit,
UpperVacuum Tube
Velcro Strap...,_ | |
Collection _ | _,... |
Bag | Blower Outlet |
|
ADJUSTING THE SHOULDER STRAP
ON THE COLLECTION BAG
1.Carefully loop the shoulder strap through the buckle as shown in the illustration below.
Last Int_
6
