Craftsman 38514 owner manual To Start Engine, Mowing, Tips

A CAUTION: Alcohol blendedfuels

(called gasoholor usingethanol or metha- nol) can attract moisturewhich leads to separationand formation of acids during storage. Acidic gas can damage the fuel system of an enginewhile in storage. To avoid engine problems,the fuel system should be emptied before storage of 30 days or longer. Emptythe gas tank, start the engine and let it run untilthe fuel lines and carburetorare empty. Use fresh fuel next season. See Storage Instructionsfor additional information. Never use engine or carburetorcleaner products in the fuel tank or permanentdamage may occur.

Engine oil cap

Primer

Gasoline filler cap

TO STOP ENGINE

•To stop engine, release operator pres- ence control bar.

TO START ENGINE

NOTE: Due to protective coatings on the engine, a small amount of smoke may be

present during the initial use of the prod- uct and should be considered normal.

1.To start a cold engine, push primer three (3) times before trying to start. Use a firm push. This step is not usually necessary when starting an engine which has already run for a few minutes.

2.Hold operator presence control bar down to the handle and pull starter handle quickly. Do not allow starter rope to snap back.

NOTE: In coolerweather it may be necessary to repeat priming steps. In warmer weather over priming may cause flooding and engine will not start. If you do flood engine, wait a few minutes before attempting to start and do not repeat priming steps.

MOWING	TIPS
_i, CAUTION:	Do not		use	de-thatcher
blade attachments		on	your	mower. Such
attachments	are	hazardous,		will	damage
your mower	and	could	void	your	warranty.

•Under certain conditions, such as very tall grass, it may be necessary to raise the height of cut to reduce pushing effort and to keep from overloading the engine and leaving clumps of grass clippings.

It may also be necessary to reduce

ground speed and/or run the lawn mower over the area a second time.

•For extremely heavy cutting, reduce the

width of cut by overlapping previously cut path and mow slowly.

•For better grass bagging and most cut- ting conditions, the engine speed should be set in the FAST position.

•For side discharge lawn mowers, cutting

in a counter-clockwise direction, start- ing at the outside of the area to be cut, spreads grass clippings more evenly and puts less load on the engine. To keep clippings off of walkways, flower beds, etc., make the first cuts in a clock- wise direction.

•Pores in cloth grass catchers can be- come filled with dirt and dust with use

and catchers will collect less grass. To prevent this, regularly hose catcher off with water and let dry before using.

•Keep top of engine around starter clear and clean of grass clippings and chaff. This will help engine air flow and extend engine life.

MULCHING MOWING TiPS

IMPORTANT: For best performance, keep mower housing free of built-up

grass and trash. See "CLEANING" in the

Maintenance section of this manual.

•The special mulching blade will recut the grass clippings many times and reduce them in size so that as they fall onto the lawn they will disperse into the grass and not be noticed. Also, the mulched grass will biodegrade quickly to provide nutrients for the lawn. Always mulch with your highest engine (blade) speed as this will provide the best recut-

ting action of the blades.

,Avoid cutting your lawn when it is wet. Wet grass tends to form clumps and interferes with the mulching action. The best time to mow your lawn is the early

afternoon. At this time the grass has dried, yet the newly cut area will not be exposed to direct sunlight.