ASSEMBLY

CARTON CONTENTS

1.Spring Tines (7)

2.Frame Assembly

3.Gauge Wheel

1

2

3

TOOLS REQUIRED FOR ASSEMBLY

(1)7/16" Wrench

(2)1/2" Wrenches

(2)3/4" or Adjustable Wrenches

(1)Knife

REMOVAL OF PARTS FROM CARTON

•Remove all parts and hardware packages from the carton. Lay out all parts and hardware and identify using the illustrations on pages 3 and 4.

•Turn the frame assembly as shown in figure 1.

•Assemble seven spring tines to the top of the frame tube. Use a 5/16" x 1-1/2" hex bolt, two 3/8" flat washers and a 5/16" nylock nut for each spring tine.

Place one 3/8" flat washer on top of the frame tube and the second 3/8" flat washer on top of the spring tine. See figure 1.

NOTE: On sweepers smaller than 42", use only five spring tines.

•Assemble a vinyl cap onto each end of the frame tube.

See figure 1.

5/16" x 1-1/2" VINYL CAP

HEX BOLT 3/8" WASHER

5/16" NYLOCK NUT

VINYL CAP

FIGURE 1

•Assemble a 1/2" washer, the wheel, another 1/2" washer and the 1/2" plain jam nut onto the

1/2" x 3-1/2" hex bolt. See figure 2.

•Insert the bolt through the welded bracket and assemble the 1/2" nylock jam nut onto the bolt. Adjust the nuts so that there is no end play in the wheel and then tighten the nuts securely against the welded bracket. Make sure the wheel still turns freely. See figure 2.

Use this hole for 42" & 46" sweepers

Use this hole for smaller sweepers

1/2" NYLOCK

JAM NUT

1/2" JAM NUT 1/2" WASHER

1/2" WASHER

1/2" x 3-1/2"

HEX BOLT

FIGURE 2