TOOLS REQUIRED FOR ASSEMBLY
(2)7/16" Wrenches
(2)1/2" Wrench
(1)1/2" or 9/16" Socket Wrench
REMOVAL OF PARTS FROM CARTON
Remove all parts and hardware packages from the carton. Lay out parts and hardware and identify using the illustrations on pages 3 and 4.
NOTE: Not all of the supplied parts and hardware witl be needed for one particular tractor. Unneeded items may be discarded after assembly has been completed.
NOTE: Right hand (RH) and left hand (LH) are
determined from the operator's position while seated on the tractor.
CAU'NON: Make sure tractor seat raises and lowers freely after attaching Snow Cab. The tractor's operator presence safety switch wilt not operate if seat is stuck down.
iNSTRUCTiONS FORTRACTORS WITH SINGLE SUSPENSION BRACKET
STEP 2: (SEE FIGURE 2)
,The four holes in the base bracket are unequal in height, Place the base bracket on a flat surface with the holes that are higher facing away from you,
,Attach the right side of the base bracket to the middle two holes in the flattened base leg tube using two 5/16" x 2" carriage bolts (B) and 5/16" nylock nuts (G), Make onJy finger tight.
,Attach the left side of the base bracket to the fourth
and fifth holes in one of the base leg tubes using two 5/16" x 2" carriage bolts (B) and 5/16" nylock nuts (G). Make only finger tight.
,Attach the long end of the right support bracket to the outside of the flattened end of the right base leg tube using a 1/4" x 1" carriage bolt (I) and 1/4" nylock nut
(F). Make only finger tight.
,Attach the left support bracket to the outside of the left base leg tube using one 5/16" x 2" hex bolt (C) and 5/16" nylock nut (G). Make only finger tight.
5/16" NYLOCK NUT (G)
1/4" NYLOCK
STEP 1 : (SEE FIGURE 1)
RIGHT
NUT (F)
,Look under the front of your tractor, If there is a single mower deck suspension bracket located underneath the middle of the front axle, continue on to step 2, If your tractor does not have a mower deck suspension bracket underneath the middle of the front axle, skip to step 5 on page 6 for tractors with dual suspension brackets,
BRACKET |
SUPPORT
BRACKET
5/16" NYLOCK NUT (G)
|
| SHORT END |
5116" | x 2" |
|
REX BOLT (C} THIS HOLE | ||
|
| IS HIGHER |
|
| BASE LEG TUBE |
|
| (FLATTENED) |
| ! | 5/16" x 2" |
| CARRmAGE BOLT (B) | |
|
| |
LEFT |
| BASE BRACKET |
SUPPORT |
| |
BRACKET |
| |
FIGURE 2
FIGURE 1
