•Slide a flanged bearing onto the axle and push it into the hole in the end plate. See figure 5.
•Drive a spring pin into the hole in the axle until the pin just extends through the other side of the axle. The spring pins secure the axle in the frame and should also prevent the axle from rotating. See figure 5.
FLANGED
BEARING
SPRING PIN
FIGURE 5
•Attach two hitch arm mount brackets to the middle holes in the rear frame angle using two 5/16" x 3/4" hex bolts and two 5/16" nylock nuts. Do not tighten completely. See figure 6.
•Attach two hitch arm mount brackets to the middle holes in the front frame angle using two 5/16" x 3/4" hex bolts and two 5/16" nylock nuts. Do not tighten completely. See figure 6
•Assemble the hitch mount arms to the outside of the four hitch arm mount brackets as shown in figure 7.
Use four 5/16" x 1" carriage bolts and four 5/16" nylock nuts. Do not tighten yet. See figure 7.
(4) 5/16" x 1" | (4) HITCH ARM |
CARRIAGE BOLTS | MOUNT |
| BRACKETS |
(4) 5/16" NUTS |
|
(NYLOCK) |
|
FIGURE 7
•Assemble the ends of the hitch mount arms together using two 5/16" x
•Assemble the hitch brackets to the hitch mount arms using two 5/16" x 2" hex bolts and two 5/16" nylock nuts as shown in figure 8. Do not tighten yet.
HITCH MOUNT ARMS
5/16" x 3/4"
HEX BOLTREAR FRAMEANGLE5/16" x 3/4"
HEX BOLT
(NYLOCK)
(2) 5/16" xFIGURE 8
FIGURE 6
•Tighten the bolts assembled in figure 6. Tighten the bolts assembled in figure 7. Tighten the bolts assembled in figure 8.
•Attach the aerator to your tractor using the hitch pin and the hair cotter pin.