CARTON CONTENTS
The following parts are shipped loose with your pressure washer:
•Main Unit
•Product IntroductionVideo
•Nozzle Cleaner Kit
•High Pressure Hose
•Parts Box (which includes items listed below
•Spray Gun
•Wand Extension with
•Wire Form
•Motor Oil
Become familiar with each piece before assemblingthe pressure washer. Check all contents against the illustra- tion on Page 6. If any parts are missing or damaged, call the Pressure Washer Helpline at
•Remove the unit by rolling it out the opening in the carton, then check carton for additional loose parts.
HOW TO SET UP YOUR PRESSURE WASHER
For the most part, your Craftsman High Pressure Washer has been assembled at the factory. You must, however, attach the wire form, assemble the spray gun, and attach the high pressure hose to the pump and spray gun.
Note: Included with your unit is a video cassette that demonstrates how to set up your pressure washer. If you have a viedo cassette recorder you may wish to view the video before assemblingyour unit.
•Insert the wire support with the longer arm positioned on the left. From this view the hook should resemble a "J".
TOOLS REQUIRED FOR ASSEMBLY
2 adjustable wrenches OR the following wrenches
•11/16" (17mm) wrench
•7/8" (23mm) wrench
TO REMOVE PRESSURE WASHER FROM CARTON
Remove loose parts and parts box included with pres- sure washer. The high pressure hose is packed in the
bottom of the carton on the guide handle end. Remove the hose.
•Slice two corners at guide handle end of carton from top to bottom so the panel can be folded down flat, then remove all packing material.
•Raise guide handle and secure in place.
Loosen knobs to
,/
raise handle
Tighten knobs when handle
straight.
LONG
ARM
SHORT
ARM
Cut lie wrap on chemical injection tube. Remove chemi- cal injectionfilter, threadchemical tube through the wire form and reinsert filter into tube.
