Craftsman 610.24610 manual Setting up Lift Mounting Hardware

Setting up Lift Mounting Hardware

Tractor Lift can be used out of the box on all Craftsman tractors with bumpers or brush guards. For tractors without bumper or brush guard, Tractor Lift mounting hardware is provided. Follow the steps below:

6

31

32

Front

IlXll

Remove,

add washer ( 24 ), replace.

6

Rear

Remove existing bolt "X" and set aside. If tractor does not

have this bolt, use supplied 3/8" x 1-1/4" bolt and 3/8" nyloc nut.

Insert bolt ( 29 ) through inside front hole of frame, through tractor bracket ( 7 ) and secure with nyloc nut ( 27 ).

Add flat washer ( 24 ) under head of bolt removed in earlier step and reinsert through tractor mounting bar and tighten.

For LT1000 & LT2000 series tractors, use self-thread bolts ( 28 ) in place of bolt ( 29 ) and nut ( 27 ).

Slide lifting bar ( 6 ) through cut-out in tractor brackets.

Pin lifting bar in place with one hairpin cotter ( 26 ) on each side, inside of tractor brackets ( 7 ).

Place lifting bar ( 6 ) under rear tractor hitch and slide threaded stud through hole.

Secure in place with flat washer ( 32 ) and hex nut ( 31 ).

FOR MISSING PARTS, Call 1-800-652-2321, Monday - Friday, 8 a.m.- 5 p.m.E.S.T.

Page 5.