Then make the final cut from the top of the branch using the bottom side of the chain. (see figure 20)
Figure 20
Making the initial cut on the underside of the branch will prevent the branch from splintering when it falls away from the tree. Never try to cut the branch completely from the underside. This will cause the branch to bind on the chain and could stall the motor causing damage to the saw.
Do not stop the saw until after it is removed from the cut. Release the trigger to stop the saw. Be sure the chain has come to a complete stop before setting the pole saw down. The chain will immediately become dull if it contacts the ground while still running.
WALL BRACKET
Mount the wall bracket securely to the wall; attach with screws to a wall stud. The use of wall board anchors is NOT recommended. Place the tool attachment in the wall bracket as shown for convenient storage. (see figure 21)
Figure 21
MAINTENANCE
WARNING: Always remove the battery when performing any maintenance on the power handle or a tool attachment that is connected to the power handle.
WARNING: Always keep hands away from the triggers when performing maintenance.
LUBRICATION – See operating instructions for specific information on lubricating the chain. Periodic lubrication of other parts is not required.
CLEANING OF PLASTIC PARTS
-Use only a dry brush or a cloth with warm water and mild soap to clean plastic parts. Many household cleaners contain chemicals which could damage the plastic. Never use gasoline, turpentine, paint thinner or similar fluids. Never
DROPPING THE UNIT - If you drop the unit, carefully inspect it for any damage before using it again. Have the unit professionally repaired if damage has occurred.
12
