Craftsman 836.27233 To Nail Figure, Into your eyes, resulting in possible serious injury, With

TO NAIL (FIGURE 2)

Always wear safety goggles or safety glasses with side shields when

operating your nailer. Failure to do so could result in objects being thrown

Do not allow familiarity of your nailer to make you careless. Remember that a careless fraction of a second is sufficient

to inflict severe injury.

into your eyes, resulting in possible serious injury.

1.Plug nailer into 120 Volt, 60Hz power outlet,

2.Hold nailer firmly with the tacking mouth (1) flat to the workpiece.

3.depressUseenoughthe safetydownwardlock pinpressure(2). to

NOTE: The safety lock pin must be depressed for this nailer to operate. This nailer will not fire uniess this

Fig. 2

4

3

_/

_,,,_ _'f-_

__ \ _ !

f/_ / /'_--._ "'-)1

	is done.						_._;_	///	k_		J
4.	Squeeze		the trigger	(3) to	drive the		_	k.'_......__		1
	brad	nail.					L	___			I
5.	If the workpiece is very hard,					press	_		_'_"		/J
	down	on the housing		cap	(4)	with		_		_'_	I/
	your	free hand.					_._
	NOTE: AVOID BLANK SHOTS to
	prevent		wear and damage		to						2
	internal		parts.							1	J

The nailer must be disconnected from

the electrical power source during maintenance.

STANDARD MAINTENANCE

1.Inspect all screws and tighten if necessary.

2.Use a clean cloth to remove dirt from the tool.

3.Do not use gasoline, brake fluid, oils, or solvents to clean plastic parts. These chemicals will damage, weaken, or destroy plastics.

4.Do not oil or grease any parts,

5.Keep the nail magazine chamber clean.

6.Do not rotate or remove housing cap.

Do not alter, redesign parts on this nailer, or attach special fixturing. This can be a source of personal injury.

Page 8