Craftsman 917-371813 manual Handle, Engine Fuel System

IMPORTANT: Never tamper with the engine governor, which is factory set for proper engine speed. Overspeeding the engine above the factory high speed

setting can be dangerous. If you think

Immediately prepare your lawn mower for storage at the end of the season or if the unit will not be used for 30 days or more.

LAWN MOWER

When lawn mower is to be stored for a period of time, clean it thoroughly, remove all dirt, grease, leaves, etc. Store in a clean, dry area.

1.Clean entire lawn mower (See

"CLEANING" in the Maintenance sec- tion of this manual).

2.Lubricate as shown in the Maintenance section of this manual.

3.Be sure that all nuts, bolts, screws, and

pins are securely fastened. Inspect

moving parts for damage, breakage and wear. Replace if necessary.

4.Touch up all rusted or chipped paint

surfaces. Be sure to sand surface

lightly before painting.

HANDLE

You can fold your lawn mower handle for storage.

1.Loosen the two (2) handle knobs on sides of the upper handle and allow handle to fold down to the rear.

OperatorMOWING

presencePOSITION control bar

Upper handle

Handle knob

Lower handle

,Remove the two (2) handle knobs and carriage bolts on sides of the lower handle and pivot entire handle as- sembly forward and allow it to rest on mower.

the engine-governed high speed needs adjusting, contact a Sears or other qualified service center, which has proper equipment and experience to make any necessary adjustments.

	\	Bolt
\	\
Knob
\

Handle bracket

3.Reinstall knobs and carriage bolts to lower handle or handle brackets for

safe keeping.

•When setting up your handle from the storage position, you must manually lock lower handle into mowing position.

IMPORTANT: When folding the handle

for storage or transportation, be sure to fold it as shown or you may damage the control cables.

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

•Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

18