TROUBLESHOOTING

 

CHART

 

 

 

 

 

PROBLEM

 

CAUSE

 

 

 

 

 

 

Engine

clicks but

Weak

or dead

battery.

will not

start

Corroded

battery

terminals.

 

 

Loose

or damaged

wiring.

 

 

Faulty

solenoid

or starter.

Loss of power

Cutting

too

much

grass/too

 

 

 

fast.

 

 

 

 

 

 

 

 

 

Throttle

in"CHOKE"

 

 

 

 

position.

 

 

 

 

 

 

 

Build-up

of

grass,

leaves

 

 

 

and

trash

under

mower.

 

 

Dirty

air filter.

 

 

 

 

 

Low

oil level/dirty

oil.

 

 

Faulty

spark plug.

 

 

 

Dirty fuel filter.

 

 

 

 

 

Stale

or dirty fuel.

 

 

 

Water

in fuel.

 

 

 

 

 

Spark

plug

wire

loose.

 

 

Dirty

engine

air screen/fins.

 

 

Dirty/clogged

muffler.

 

 

Loose

or damaged

wiring.

 

 

Carburetor

out of

 

 

 

 

adjustment.

 

 

 

 

 

 

Engine valves

out of

 

 

 

adjustment,

 

 

 

 

Excessive

 

Worn,

bent

or

loose blade.

vibration

 

 

 

 

 

 

 

 

 

 

 

 

Bent

blade

mandrel.

 

 

 

Loose/damaged

 

part(s).

Enginecontinues

Faulty

operator-safety

to run

 

 

presence

control system.

when operator

 

 

 

 

 

 

 

 

 

 

leaves

seat

 

 

 

 

 

 

 

 

 

with attachment

 

 

 

 

 

 

 

 

 

clutch

engaged

 

 

 

 

 

 

 

 

 

ICORRECTION

Recharge or replace battery.

Clean battery terminals.

Check all wiring.

Check/replace solenoid or starter.

Set in "Higher Cut" position/ reduce speed.

Adjust throttle control.

Clean underside of mower housing.

Clean/replace air filter.

Check oil level/change oil.

Clean and regap or change spark plug.

Replace fuel filter.

Drain fuel tank and refill with fresh gasoline.

Drain fuel tank and carbure tor, refill tank with fresh

gasoline and replace fuel filter.

Connect and tighten spark plug wire.

Clean engine air screen/fins.

Clean/replace muffler.

Check all wiring.

See "To Adjust Carburetor" in

Service Adjustments section.

Contact an authorized service center/department.

Replace blade.

Tighten blade bolt.

Replace blade mandrel.

Tighten loose part(s). Replace damaged parts.

Check wiring, switches and connections. If not

corrected, contact an autho rized service center/

department.

29

Page 29
Image 29
Craftsman 917.27105 manual Cause, Problem