The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses I or eye shields while operating your tractor or performing any adjustments I or repairs. We recommend standard safety glasses or a wide vision safety I

mask worn over spectacles.

I

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

1.Depress clutch/brake pedal all the way down and hold.

2.Pull parking brake lever up and release pressure from clutch/brake pedal.

Pedal should remain in brake position.

Make sure parking brake will hold trac- tor secure.

"Brake" Attachment Clutch

Throttle/Choke Position Lever "Engaged"

Control

Key

 

"Disengaged"

Brake

 

Pedal

Parking Brake

 

Position

"Disengaged" Position

Control Lever

STOPPING

MOWER BLADES -

To stop mower blades, move attach-

ment clutch lever to disengaged posi- tion.

GROUND DRIVE -

To stop ground drive, depress clutch/ brake pedal all the way down.

Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever

does not return to neutral (N) position when the clutch/brake pedal is depressed.

ENGINE -

• Move throttle control between half and

full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) posi-

tion, before stopping, may cause engine to "backfire".

Turn ignition key to "STOP" position and remove key. Always remove key when

leaving tractor to prevent unauthorized

use.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will

cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas.

_J_CAUTION: Always stop tractor com- pletely, as described above, before leaving the operator'sposition.

TO USETHROTTLE CONTROL Always operate engine at full throttle.

Operating engine at less than full

throttle reduces the battery charging rate.

Full throttle offers the best bagging and mower performance.

TO MOVE FORWARD AND BACKWARD

The direction and speed of movement is

controlled by the motion control lever.

1. Start tractor with motion control lever in neutral (N) position.

2, Release parking brake,

3.Slowly move motion control lever to desired position.

TO ADJUST MOWER CU'I-rlNG HEIGHT The position of the attachment lift lever determines the cutting height.

Grasp lift lever.

Press plunger with thumb and move

lever to desired position.

The cutting height range is approxi- mately 1-1/2 to 4". The heights are mea- sured from the ground to the blade tip with the engine not running. These heights

are approximate and may vary depending upon soil conditions, height of grass and types of grass being mowed.

The average lawn should be cut to ap- proximately 2-1/2 inches during the cool

season and to over 3 inches during hot months. For healthier and better look-

ing lawns, mow often and after moder- ate growth.

For best cutting performance, grass over 6 inches in height should be mowed twice. Make the first cut rela-

Never use choke to stop engine.

13 tively high; the second to desired height.

Page 13
Image 13
Craftsman 917.273180 HOW to USE Your Tractor, To SET Parking Brake, Stopping Mower Blades, To Move Forward and Backward