TO REMOVE CABLES, REVERSE ORDER -
1.BLACK cable first from chassis and then from the fully charged battery.
2.RED cable last from both batteries.
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in the backside of the grill.
4.Close hood.
02614
Weak or Dead Fully Charged
BatteryBattery
REPLACING BATTERY
WARNING" Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
7.Connect BLACK grounding cable to negative
8.Close terminal access doors.
9.Close hood.
'e0sHexLBolt
Terminal
Access
Door | / |
|
|
|
| I r_._ositive |
|
| |
| _ |
| _I | |
| _.... | ! _ | _ | Cable |
| Terminal | ;_.,.,. _Neaative | ||
| Guard |
| (Black) | |
|
|
|
| Cable |
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 20 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at
sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
Hood
Headlight Wire
Connector
O2495 "
25
