To Move Forward and Backward, Stopping

The operation of any tractor can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields while operating your tractor or performing any adjustments or repairs. We recommend standard safety glasses or a wide vision safety mask worn over spectacles.

HOW TO USE YOUR TRACTOR

TO SET PARKING BRAKE

Your tractor is equipped with an operator presence sensing switch. When engine is running, any attempt by the operator to leave the seat without first setting the parking brake will shut off the engine.

1.Depress clutch/brake pedal all the way down and hold.

2.Pull parking brake lever up and release pressure from clutch/brake pedal. Pedal should remain in brake position. Make sure parking brake will hold trac- tor secure.

Attachment Clutch Lever

Throttle/"Engaged" Position

Choke

Control

nition Key

"Brake"		"Disengaged"
"Brake"		Position
Position		Position
Position
	Motion Control
	Lever
	///		Parking
Clutch/Brake		_	Brake
Pedal	"Disengaged	....	Engaged"
	Position		Position

STOPPING

MOWER BLADES -

•To stop mower blades, move attachment

clutch lever to "DISENGAGED" position.

GROUND DRIVE -

•To stop ground drive, depress clutch/ brake pedal all the way down.

•Move motion control lever to neutral (N)

position.

IMPORTANT: The motion control lever does not return to neutral (N) position when the clutch/brake pedal is depressed.

ENGINE -

•Move throttle control between half and

full speed (fast) position.

NOTE: Failure to move throttle control between half and full speed (fast) posi-

tion, before stopping, may cause engine to "backfire".

•Turn ignition key to "STOP" position and remove key. Always remove key when leaving tractor to prevent unauthorized use.

•Never use choke to stop engine.

IMPORTANT: Leaving the ignition switch in any position other than "STOP" will

cause the battery to discharge and go dead.

NOTE: Under certain conditions when tractor is standing idle with the engine running, hot engine exhaust gases may cause "browning" of grass. To eliminate this possibility, always stop engine when stopping tractor on grass areas.

_,CAUTION: Always stop tractor com- pletely, as described above, before leaving the operator's position.

TO USE THROTTLE CONTROL

Always operate engine at full throttle.

•Operating engine at less than full throttle reduces the battery charging rate.

•Full throttle offers the best bagging and mower performance.