DD
02614
Weak or Dead Fully Charged
BatteryBattery
REPLACING BATTERY
,_WARNING: Do not short battery terminals by allowing a wrench or any other object to contact both terminals at the same time. Before connecting battery, remove metal bracelets, wristwatch bands,
rings, etc.
Positive terminal must be connected first to prevent sparking from accidental grounding.
1.Lift hood to raised position.
2.Remove terminal guard.
3.Disconnect BLACK battery cable then RED battery cable and carefully remove battery from tractor.
4.Install new battery with terminals in same position as old battery.
5.Reinstall terminal guard.
6.First connect RED battery cable to positive (+) battery terminal with hex bolt and keps nut as shown. Tighten securely.
7.Connect BLACK grounding cable to negative
maining hex bolt and keps nut. Tighten securely
8.Close terminal access doors.
9.Close hood.
| Keps |
|
Terminal | Hex | |
Access | ,, | Bolt |
Door |
| Positive |
|
| (Red) Cable |
Guard |
| ,gative (Black) |
|
| Cable |
TO REPLACE HEADLIGHT BULB
1.Raise hood.
2.Pull bulb holder out of the hole in the backside of the grill.
3.Replace bulb in holder and push bulb holder securely back into the hole in
the backside of the grill.
4.Close hood.
INTERLOCKS AND RELAYS
Loose or damaged wiring may cause
your tractor to run poorly, stop running, or prevent it from starting.
•Check wiring. See electrical wiring
diagram in the Repair Parts section.
TO REPLACE FUSE
Replace with 30 amp
TO REMOVE HOOD AND GRILL AS- SEMBLY
1.Raise hood.
2.Unsnap headlight wire connector.
3.Stand in front of tractor. Grasp hood at sides, tilt toward engine and lift off of tractor.
4.When replacing hood, be sure to re- connect the headlight wire connector.
.Hood
Headlight Wire
Connector
ENGINE
Maintenance, repair, or replacement of the emission control devices and systems, which are being done at the customers ex- pense, may be performed by any
engine repair establishment or individual. Warranty repairs must be performed by an authorized engine manufacturer's service outlet.
TO ADJUST THROTTLE CONTROL CABLE
The throttle control has been preset at the factory and adjustment should not be nec- essary. Check adjustment as described below before loosening cable. If adjust- ment is necessary, proceed as follows:
1.With engine not running, move throttle control lever to fast position.
2.Check that speed control lever is against stop screw. If it is not, loosen casing clamp screw and pull throttle cable until lever is against screw. Tighten clamp screw securely.
27