Craftsman 917.28035 owner manual pan Tape Wiring harness

/

pan

Tape

Wiring harness

Raise seat and tighten bolt securely. Remove tape and discard.

Lower seat into operating position and sit on seat. Press brake pedal all the way down. If operating position is not

comfortable, adjust seat.

Slot	Tape
Pad
Flat
washer

	Seat
	pan	Adjustment
Bolt	Tab	handle

TO ADJUST SEAT

Grasp adjustment handle and pull up, slide

seat to desired position and release adjust- ment handle.

NOTE: You may now roll your tractor off

the skid. Follow the instructions below to remove the tractor from the skid.

WARNING: Before starting, read, un-

derstand and follow all instructions in the

Operation section of this manual. Be sure

tractor is in a well-ventilated area. Be sure the area in front of tractor is clear of other people and objects.

TO ROLL TRACTOR OFF SKID (See Operation section for location and function of controls)

1.Raise attachment lift lever to its highest position.

2.Release parking brake by depressing

clutch/brake pedal.

3.Place gearshift lever in neutral position.

4.Roll tractor forward off skid.

5.Remove banding holding the deflector shield up against tractor.

Continue with the instructions that follow.

TO ASSEMBLY BAGGER

1.Unfold bag and stand right side up.

2.Feed front bagger frame (1) up through fabric loops at each side of bagger.

3.Snap bottom offront baggerframe (1) into snap feature at front of bagger bottom.

4.Slide baggerfabricloop (2) segmentsatthe ends of bag onto top bagger frame tubing.

5.Uninstall two (1\4"-20 x 1.15") hex bolts

(3)from the front of top frame.

6.Reinstall the two (1\4"-20 x 1.15") hex bolts (3) through holes at top of the front bagger frame and thread into nuts inside

the tubing of top bagger frame.

7.Uninstall (1/4"-20)lock nuts (4) at bottom of front bagger frame.

8.Unfold cross braces (5) and attach to carriage bolts at bottom corners of front bagger frame.

9.Reinstall (1/4"-20) lock nuts (4) and tighten until fully seated.

10.Remove clevis pin (6) and retainer spnng

(7)from bagger handle (8).

11.Slide bagger handle (8) downthrough bag-

gercoverandframeupperweldment holes.

12.Reinstall clevis pin (6) through hole at bottom of bagger handle and slide retainer spring (7) into hole at the end of the clevis pin until it locks into place