Craftsman 917.28945 owner manual To Remove Mower, To Install Mower

WARNING: TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:

1.Depress clutch/brake pedal fully and set parking brake. 2, Place gearshift lever in neutral position.

3, Place attachment clutch in "DISENGAGED" position,

4. Turn ignition key to "STOP" and remove key,.

5, Make sure the blades and all moving parts have completely stopped.

6o Disconnect spark plug wire from spark plug and place wire where it cannot come in contact with plugo

TO REMOVE MOWER

1.Place attachment clutch in "DISEN- GAGED" position.

2.Lower attachment lift lever to its lowest

position.

3, Disengage belt tension rod (K) from lock bracket (L).

CAUTION; Belt tension rod is spring

loaded. Have a tight grip on rod and release slowly.

4.Remove mower belt from electric clutch pulley (M),

5.Disconnect front link (E) from mower - remove retainer spring and washer.,

6.Go to either side of mower and disconnect mower suspension arm (A) from chas- sis and rear lift link (C) from rear mower

bracket (D) -remove retainer springs and washers_

7.Go to others!de ofmowerand disconnect the suspension arm and rear lift link_

_h, CAUTION: After rear lift links are discon-

nected, the attachment lift lever will be spring loaded. Have a tight grip on lift lever when changing position of the lever.

8, From right side of mower, disconnect anti-sway bar (S) from right rear mower bracket (D) - remove retainer spring and washer and pull mower toward you until the bar falls from the hole in bracket.

9.Turn tractor steering wheel to the left as far as it will go,

10oSlide mower out from under right side of tracton

TO INSTALL MOWER

Follow procedure described in "INSTALL

MOWER AND DRIVE BELT" in the Assembly section of this manual,

25