Craftsman 917.37181 owner manual to a Sears Parts & Repair Center, Problem, Cause, Does not start

Models: 917.37181

1 52
Download 52 pages 60.68 Kb
Page 19
Image 19
to a Sears Parts & Repair Center.

Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-

buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

Do not store gasoline from one season to another.

Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

If possible, store your unit indoors and cover it to protect it from dust and dirt.

Cover your unit with a suitable protec- tive cover that does not retain moisture. Do not use plastic. Plastic cannot breathe, which allows condensation to

form and will cause your unit to rust.

IMPORTANT: Never cover mower while engine and exhaust areas are still warm.

_IbCAUTION: Never store the lawn mower

with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TROUBLESHOOTING - See appropriate section in manual unless directed

to a Sears Parts & Repair Center.

PROBLEM

Does not start

 

CAUSE

 

 

 

 

CORRECTION

 

 

 

 

1.

Dirty

air filter.

 

 

 

1.

Clean/replace

air filter.

 

2.

Out

of

fuel.

 

 

 

 

2.

Fill fuel

tank.

 

 

 

3.

Stale

 

fuel.

 

 

 

 

3.

Empty

fuel

tank

and refill

tank

4.

Water

in fuel.

 

 

 

 

with fresh,

clean

gasoline.

 

 

 

 

4.

Empty

fuel

tank

and refill

tank

 

 

 

 

 

 

 

 

 

with fresh,

clean

gasoline.

 

5.

Spark

plug

wire

is

 

5.

Connect

wire

to

plug.

 

 

disconnected.

 

 

 

 

 

 

 

 

 

 

6.

Bad

spark

plug.

 

 

6.

Replace

spark

plug.

 

7.

Loose

blade

or

broken

7.

Tighten

blade

bolt or

 

 

blade

adapter.

 

 

 

 

replace

blade

adapter.

 

8.

Control

bar

in released

8.

Depress

control

bar to

 

 

position.

 

 

 

 

 

handle.

 

 

 

 

 

9.

Control

bar

defective.

9.

Replace

control

bar.

 

10.

Fuel

valve

lever

(if

so

10.

Turn fuel valve

 

lever

 

 

equipped)

in

OFF

position.

 

to the ON

position.

 

11.

Weak

battery

(if equipped).

11.

Charge

battery.

 

 

12. Disconnected

battery

12.

Connect

battery

to engine.

 

 

connector

(if

equipped).

 

 

 

 

 

 

 

19

Page 19
Image 19
Craftsman 917.37181 owner manual to a Sears Parts & Repair Center, Problem, Cause, Does not start