ENGINE
FUEL SYSTEM
IMPORTANT: It is important to prevent
gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation
of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.
•Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.
•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.
•Use fresh fuel next season.
NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio
found on stabilizer container. Run engine
at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-
buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.
ENGINE OIL
Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).
CYLINDER
1. Remove spark plug.
2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.
3.Pull starter handle slowly a few times to distribute oil.
4.Replace with new spark plug.
BATTERY
Disconnect the battery from the engine connector and charge battery 48 hours.
OTHER
•Do not store gasoline from one season to another.
•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.
•If possible, store your unit indoors and cover it to protect it from dust and dirt.
•Cover your unit with a suitable protec- tive cover that does not retain moisture.
Do not use plastic. Plastic cannot breathe, which allows condensation to
form and will cause your unit to rust. IMPORTANT: Never cover mower while
engine and exhaust areas are still warm. ,I_CAUTION: Never store the lawn
mower with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.
TROUBLESHOOTING =See appropriate section in manual unless directed
to a Sears Parts & Repair Center. |
|
|
|
|
|
|
|
| |||||||
PROBLEM |
| CAUSE |
|
|
|
| CORRECTION |
|
|
| |||||
Does not start | 1. | Dirty | air filter. |
| 1. | Clean/replace | air filter. |
| |||||||
| 2. | Out | of fue!. |
|
| 2. | Fill | fuel | tank. |
|
|
| |||
| 3. | Stale | fuel. |
|
| 3. | Empty fuel | tank | and refill | tank | |||||
| 4. | Water | in fuel. |
|
| with | fresh, | clean | gasoline. |
| |||||
|
| 4. | Empty fue! | tank | and refill | tank | |||||||||
|
|
|
|
|
|
|
|
| with | fresh, | clean | gasoline. |
| ||
| 5. | Spark | plug | wire disconnected. | 5. | Connect | wire to plug. |
| |||||||
| 6. | Bad spark | plug. | 6. | Replace | spark | plug. |
| |||||||
| 7. | Loose |
| blade | or broken | 7. | Tighten | blade | bolt or |
| |||||
|
| blade | adapter. |
| replace | blade | adapter. |
| |||||||
| 8. | Control | bar | in released | 8. | Depress | control | bar to |
| ||||||
|
| position. |
|
|
| handle. |
|
|
|
|
| ||||
| 9. | Control | bar defective. | 9. | Replace | control | bar. |
| |||||||
| 10. | Fuel | valve | lever (if so | 10.Turn | fuel valve | lever |
| |||||||
|
| equipped) | in OFF position. |
| to the ON | position. |
| ||||||||
| 11. | Weak |
| battery | (if equipped). | 11. | Charge | battery. |
|
| |||||
| 12. | Disconnected | battery | 12. | Connect | battery | to engine. | ||||||||
|
| connector | (if equipped). |
|
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
| 19 |
|
|
|
|
|
|
|
|
