Craftsman 917.374355 To Remove Mower from Carton, To Unfold Handle, To Assemble Grass Catcher

Read these instructions and this manual in its entirety before you attempt to assemble or operate your new lawn mower.

IMPORTANT: This lawn mower is shipped WITHOUT OIL OR GASOLINE in the engine. Your new lawn mower has been assembled at the factory with the exception of those parts left unassembled for shipping purposes. To ensure safe and proper operation of your lawn mower, all parts and hardware you assemble must be tightened securely. Use the correct tools as necessary to ensure proper tightness. All parts such as nuts, washers, bolts, etc., necessary to complete the assembly have been placed in the parts bag.

TO REMOVE MOWER FROM CARTON	Handle
	bracket

1.Remove loose parts includedwith mower.

2.Cut down two end corners of carton

and lay end panel down flat.		Knob	,-_
3. Remove all packing	materials	except
padding between upper and lower			Bolt
handle and padding	holding	operator

presence control bar to upper handle.

4.Roll lawn mower out of carton and check carton thoroughly for additional loose parts.

NOW TO SET UP YOUR MOWER

TO UNFOLD HANDLE

iMPORTANT: Unfold handle carefully so as not to pinch or damage control cables.

1.Raise handles until lower handle sec-

tion locks into place in mowing posi- tion.

2.Remove protective padding, raise up- per handle section into place on lower handle and tighten both handle knobs.

3.Remove handle padding holding operator presence control bar to upper handle.

Your lawn mower handle can be adjusted for your mowing comfort. Refer to "AD-

JUST HANDLE" in the Service and Adjust- ments section of this manual.

TO ASSEMBLE GRASS CATCHER

1.Put grass catcher frame into grass bag

with rigid part of bag on the bottom. Make sure the frame handle is outside

of the bag top.

2.Slip vinyl bindings over frame.

NOTE: If vinyl bindings are too stiff, hold them in warm water for a few minutes. If

bag gets wet, let it dry before using.

Operator	MOWING
I:	POSITION
control bar
	////
/	//
///
	Upper
UP	handle
	Handle
	knob
	Lower handle

><-

VinylFrame

bindingsopening

TO iNSTALL ATTACHMENTS

Your lawn mower was shipped ready to be used as a mulcher. To convert mower to

bagging or discharging, see "TO CON- VERT MOWER" in the Operation section of this manual.

6