Craftsman 917.376233 owner manual Other, Fuel System, Engine OIL, Cylinder

ENGINE

FUEL SYSTEM

IMPORTANT: It is important to prevent

gum deposits from forming in essential fuel system parts such as carburetor, fuel filter, fuel hose, or tank during storage. Alcohol blended fuels (called gasohol or using ethanol or methanol) can attract moisture which leads to separation and formation

of acids during storage. Acidic gas can damage the fuel system of an engine while in storage.

•Empty the fuel tank by starting the en- gine and letting it run until the fuel lines and carburetor are empty.

•Never use engine or carburetor cleaner products in the fuel tank or permanent damage may occur.

•Use fresh fuel next season.

NOTE: Fuel stabilizer is an acceptable alternative in minimizing the formation of fuel gum deposits during storage. Add stabilizer to gasoline in fuel tank or stor- age container. Always follow the mix ratio

found on stabilizer container. Run engine

at least 10 minutes after adding stabilizer to allow the stabilizer to reach the car-

buretor. Do not empty the gas tank and carburetor if using fuel stabilizer.

ENGINE OIL

Drain oil (with engine warm) and replace with clean engine oil. (See "ENGINE" in the Maintenance section of this manual).

CYLINDER

1.Remove spark plug.

2.Pour one ounce (29 ml) of oil through spark plug hole into cylinder.

3.Pull starter handle slowly a few times to distribute oil.

4.Replace with new spark plug.

OTHER

•Do not store gasoline from one season to another.

•Replace your gasoline can if your can starts to rust. Rust and/or dirt in your gasoline will cause problems.

•If possible, store your unit indoors and cover it to protect it from dust and dirt.

•Cover your unit with a suitable protec- tive cover that does not retain moisture.

Do not use plastic. Plastic cannot breathe, which allows condensation to

form and will cause your unit to rust. IMPORTANT: Never cover mower while

engine and exhaust areas are still warm.

ACAUTION: Never store the lawn

mower with gasoline in the tank inside a building where fumes may reach an open flame or spark. Allow the engine to cool before storing in any enclosure.

TROUBLESHOOTING =See appropriate section in manual unless directed

to a Sears Parts & Repair Center.

PROBLEM CAUSE CORRECTION

Does not start	.	Dirty	air		filter.
	2.	Out	of fue!.
	3.	Stale		fuel.
	4.	Water		in fuel.
	5.	Spark		plug wire is
		disconnected.
	6.	Bad spark					plug.
	7.	Loose		blade				or broken
		blade		adapter.
	8.	Control			bar		in released
		position.
	9.	Control			bar		defective.
	10. Fuel valve lever (if so
		equipped)				in OFF position.
	11.	Weak		battery				(if equipped).
	12. Disconnected							battery
		connector				(if equipped).
	13. Blown fuse (if equipped).

. Clean/replace air filter.

2.Fill fuel tank.

3.Empty fuel tank and refill tank with fresh, clean gasoline.

4.Empty fuel tank and refill tank with fresh, clean gasoline.

5.Connect wire to plug.

6.Replace spark plug.

7.Tighten blade bolt or replace blade adapter.

8.Depress control bar to handle.

9.Replace control bar.

10.Turn fuel valve lever to the ON position.

11.Charge battery.

12.Connect battery to engine.

13.Replace fuse.

18